Installation - Gima H100 Instrucciones Para El Uso

The autoclave is tested and checked in the factory; so it does not need any other calibration before installing
and for setting.
Unpack the unit and install it as instructed (see picture no. 5)
1. Put the autoclave on a level surface.
2. Leave at least cm 10 all around the autoclave to have enough airing.
3. Do not install the autoclave in places with poor ventilation.
4. Install the autoclave so that the supply cable is not folded and it can be free to socket.
5. Do not install the autoclave near sinks or other sources producing water sprinklings to avoid short
circuits of the electrical system.
6. Do not install the autoclave near machines producing fumes or powders (ie. buffers, etc).
Attention
!
On the back of the autoclave there is a security valve : the autoclave has therefore to be put
in a position where it cannot damage people or things in case of outputting hot steam.
!
Once installed and connected, the unit is ready for use.
Autoclave GIMA H100 automatic
8

INSTALLATION

- 57 -