Troubleshooting Tips - GE JVX3240 Manual Del Propietario E Instalación

15
OPTIONAL POWER CORD KIT
JXHC1 (Cont.)
Cord Kit Grounding Instructions
If not connected directly to permanent house
wiring, this appliance must be connected to a
grounded electrical outlet to prevent a risk of
electric shock. This appliance may be used with a
cord having a grounding wire with grounding plug
connected to a properly installed and grounded
outlet. Use only an approved Power Cord Kit with
this hood. The JXHC1 is the only power supply
cord kit approved for use with this hood. Use of other unapproved power supply cord kit may
result in risk of fire or electrical shock.
WARNING
FOR PERSONAL SAFETY,
THIS APPLIANCE MUST BE PROPERLY
GROUNDED.
Improper grounding can result in a risk of
electric shock. Consult a qualified electrician to
ensure the appliance is properly grounded. Do
not use an extension cord or adapter plug. If the
power supply cord is too short, have a qualified
electrician install an outlet near the appliance.
Troubleshooting tips ... Before you call for service
Save time and money! Review the charts on the following pages first and you may not need to call for service.
Problem
Fan/Light does not
operate when either
button is pressed
Loud or abnormal
airflow noise
Fan fails to circulate
air or moves air slower
than normal and/or
fan is making loud or
abnormal airflow noise
Early light failure
49-80839-1
Installation Instructions
Possible Cause
A house fuse may be blown or a circuit
breaker tripped.
Wrong duct size used in installation.
Obstructions in duct work.
Damper blade on wall or roof cap may
not be open.
Metal grease filter and charcoal filter (if
present) may be dirty.
Insufficient makeup (replacement) air
Light wattage is too high.
16
FINISH THE INSTALLATION
1. For recirculation: Install the charcoal filter.
Metal grease filter or charcoal filter
2. For ducted installation: Install the grease filters.
Metal grease filter
What To Do
Replace fuse or reset circuit breaker.
Using smaller duct pipe will cause reduced venting.
Minimize the duct run length and number of transitions
and elbows. GE Appliances service technicians cannot
correct this issue if installed improperly.
Make sure nothing is blocking the vent. Make sure your
wall or roof cap has a blade or door.
Make sure damper swings freely. Damper blades may
flip over and will not fully open when this happens.
Adjust to original position.
Clean the metal grease filter and replace charcoal filter
(if present). See Care and Cleaning of the Vent Hood.
Sufficient makeup (replacement) air is required for
exhausting appliances to operate to rating. Check with
local building codes, which may require or strongly
advise the use of makeup air. Visit GEAppliances.com
for available makeup air solutions.
Replace with correct wattage.
17