Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Saw band teeth side-set
The width of side-set should be 0,15 - 0,3 mm each
side, depending on the blade thickness, type and
moisture contents of the wood, and must not exceed
half of the saw band width even when cutting wet wood.
Only the upper third of the tooth height should be side-
set, absolute maximum is upper half of the tooth height.
If the side set reaches down too much, the teeth are
stressed excessively at their roots from flexing of the
saw band, abnormal strain appears, the teeth roots
become weakest points of the saw band, and cracks
occurs at the roots of the teeth.
Sharpening of the saw bands
Care is to be taken when filing the saw bands manually
that edges of the file are sufficiently rounded, because
files with sharp edges contribute to formation of cracks.
When grinding machines are used for sharpening, care
must be also taken that the roots of teeth get a good
radius. Make sure that too much material is not taken
off at once, otherwise the tooth tips overheat and
become brittle. Coarse grinding wheels must not be
used, as they create rough surface giving rise to
concentration of stress and crack formation therefore.
Maintenance and care
The portable band saw requires practically no
maintenance. The saw requires no additional
lubrication. It is advisable to remove accumulated
sawdust and chips regularly.
Storage
Packed electric tools may be stored in dry unheated
storerooms with temperatures not dropping below -5°C.
Unpacked electric tools shall be stored only in dry self-
contained storerooms with temperatures not dropping
below +5°C, where sudden temperature changes are
prevented.
Recycling
After their service life is ended, submit the electric tool,
its accessories and packages to a disposal premise to
allow reusing of the raw materials.
To allow material-sorted recycling, all plastic
components are marked with relevant symbols.
Repairs and servicing
Repairs in the warranty and post-warranty periods are
carried out by the servicing workshops listed in the
index of addresses.
GB
Guarantee
We guarantee PROTOOL appliances in accordance
with statutory/country-specific regulations (proof of
purchase by invoice or delivery note).
Damage attributable to normal wear and tear, overload
or improper handling will be excluded from the
guarantee.
In case of compliant please send the machine,
undismantled, to your dealer or the Service Centre for
electric power tools.
Noise/vibration information
Noise and vibration levels measured and determined
according to EN 50144.The typical A-weighted noise
levels of the electric tool are:
Sound pressure level: 90 dB(A);
Sound power level: 103 dB(A).
Use ear protection!
The typical level of hand-arm vibration is less than
2,5 m/s .
2
Product conformity declaration
We declare with our full responsibility that this product
complies with the requirements of the following
standards and regulations:
EN 50 144-1, EN 55 144-2-14, EN 55 014-1,
EN 55 014-2, EN 61 000-3-2, EN 61 000-3-3
according to the provisions of the directives
89/336/EEC, 98/37/EC.
Manfred Kirchner
10
Tabla de contenido
