Tabla de contenido
Idiomas disponibles
Idiomas disponibles
●
Vacuum cleaner is a universal device with
a switchable sucking brush nozzle, which is used
for vacuuming hard floors and carpets.
Technical parameters
The type of the vacuum cleaner and the technical
parameters are indicated on the rating label. Mains
protection 16 A.
Does not cause interferences with audio/video devices.
The device meets the requirements of Commission
Regulation (EU) No. 666/2013 on implementing
the Directive of the European Parliament and of the
Council 2009/125/EC with regard to eco-design
requirements for vacuum cleaners.
The device complies with the requirements of the
Commission Delegated Regulation (EU) No. 665/2013
supplementing Directive of the European Parliament
and of the Council 2010/30/EU with regard to energy
labelling of vacuum cleaners.
Noise level: 82 dB(A).
Static electricity
In the process of vacuuming of some surfaces in areas
of low air humidity the device may become electrically
charged. It is a natural phenomenon – it does not
damage the device, and it is not considered to be a fault.
In order to minimize the phenomenon, we recommend
you to:
● discharge the device by touching metal items in the
room with the pipe,
● increase air humidity in the room,
● use widely available antistatic agents.
Appliance elements
1
Outlet filter cover
2
Suction brush fastening clip
3
Plug and cord
4
Cord rewind button
5
Suction power slider
6
Front cover
7
ON/OFF button
8
Front cover interlock
9
Handle
10
Suction hose
11
Telescopic suction tube
12
Outlet filter (fitted inside the vacuum)
13
Basic EPA filter (fitted inside "CYCLONE" dust
container)
14
Foam filter (fitted inside "CYCLONE" dust container)
15
"CYCLONE" dust container (vacuum' s removable
module)
16
Combination suction brush
17
Crevice nozzle
18
Small brush
19
Small nozzle
Preparing vacuum cleaner for
operation
1
Insert the end of the suction hose into the vacuum' s
opening. If you hear a click, it means that the hose has
been attached correctly.
2
Connect the other end of the hose (handle) with
the suction tube. In order to do it, press latch "A" and
insert the tube into the hose' s handle so that latch "A" is
blocked in opening "B".
3
Adjust the telescopic suction tube to the desired
length by sliding the slider according to the arrow and
pull the tube out/in.
4
Attach the selected nozzle or brush to the other end
of the suction tube.
5
Combination suction brush may be used to vacuum
hard flooring and carpets. In order to vacuum hard
surfaces – wooden, plastic floors, ceramic tiles, etc. pull
the brush out by pressing the switch on the suction brush
according to the drawing
carpets, hide the brush (set the switch on the suction
brush to "
6
A
Grab the plug (3) and pull the cord out.
When pulling the power cord out, beware
of the yellow stripe signaling the end of
the cord. Persistent pulling (pulling on),
may damage the cord. The red stripe is to tell
you that you cannot pull the cord anymore.
7
Insert the plug into the power outlet.
Before starting the vacuum, make sure that both
"CYCLONE" dust container has been fitted inside the
vacuum' s compartment and the outlet and inlet filters
have been installed.
8
Switch the vacuum cleaner on by pressing ON/OFF
button (7).
. When vacuuming
").
B
Tabla de contenido
