●
Vacuum cleaner is a universal device with
a switchable sucking brush nozzle, which is used
for vacuuming hard floors and carpets.
Technical parameters
The type of the vacuum cleaner and the technical
parameters are indicated on the rating label. Mains
protection 16 A.
Does not cause interferences with audio/video devices.
The device meets the requirements of Commission
Regulation (EU) No. 666/2013 on implementing
the Directive of the European Parliament and of the
Council 2009/125/EC with regard to eco-design
requirements for vacuum cleaners.
The device complies with the requirements of the
Commission Delegated Regulation (EU) No. 665/2013
supplementing Directive of the European Parliament
and of the Council 2010/30/EU with regard to energy
labelling of vacuum cleaners.
Noise level: 71 dB(A).
Static electricity
In the process of vacuuming of some surfaces in areas
of low air humidity the device may become electrically
charged. It is a natural phenomenon – it does not
damage the device, and it is not considered to be a fault.
In order to minimize the phenomenon, we recommend
you to:
● discharge the device by touching metal items in the
room with the pipe,
● increase air humidity in the room,
● use widely available antistatic agents.
Appliance elements
1
Suction brush fastening clip
2
Outlet filter cover
3
Plug and cord
4
ON/OFF button
5
Knob regulating suction power
6
Bag filling indicator
7
Cord rewind button
8
Handle
9
Front cover interlock
10
Suction hose
11
Inlet filter (fitted inside the vacuum)
12
Inlet filter casing (installed in the vacuum cleaner)
13
Outlet filter (fitted inside the vacuum)
14
Telescopic suction tube
15
SAFBAG dust bag (1 pcs.)
16
Small brush
17
Small nozzle
18
Crevice nozzle
19
Combination suction brush
20
Brush Natural Bristle "BNB"
(for cleaning and polishing hard, scratch-sensitive
surfaces, such as wooden floors, panels, parquet,
marble, tiles, etc.; delicate and soft natural bristle
ensures maximum effectiveness of vacuuming and
protects the surfaces cleaned against scratching)
21
SAFBAG handle
Preparing vacuum cleaner for
operation
1
Insert the end of the suction hose into the vacuum' s
opening. Make sure the splines on the hose ending fit
into the special cutting in the vacuum' s inlet opening
and turn the suction hose ending clockwise until it stops.
2
Connect the other end of the hose (handle) with
the suction tube. In order to do it, press latch "A" and
insert the tube into the hose' s handle so that latch "A"
is blocked in opening "B".
3
Set the desired length of the tube by sliding the
slider according to the arrow and pull the tube in/out.
4
Attach the selected nozzle or brush to the other end
of the suction tube.
5
Combination suction brush may be used to vacuum
hard flooring and carpets. In order to vacuum hard
surfaces - wooden, plastic floors, ceramic tiles, etc.
A
pull the brush out by pressing the switch on the
suction brush according to the drawing
vacuuming carpets, hide the brush (set the switch on
the suction brush to "
6
Grab the plug (3) and pull the cord out.
When pulling the power cord out, beware
of the yellow stripe signaling the end of
the cord. Persistent pulling (pulling on),
may damage the cord. The red strip is to tell
you that you cannot pull the cord anymore.
7
Insert the plug into the power outlet.
. When
").
B