Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5.
Using a garden hose, remove additional debris by
back flushing water through nozzle extension.
Back flush between 30 to 60 seconds.
6.
Reinstall spray tip and in-line filter into nozzle
extension.
7.
Reconnect nozzle extension to spray gun.
8.
Reconnect water supply, turn on water, and start
engine.
9.
Test pressure washer by operating with each
quick connect spray tips.
O-Ring
Maintenance
Purchase an O-Ring Repair Kit at your local Sears or by
calling 1-800-366-PART or online at ,,_,uw.sears.com. it
is not included with the pressure washer. This kit
includes replacement o-rings, rubber washer and water
inlet filter. Refer to the instruction sheet provided in the
kit to service your unit's o-rings.
l
1
• NEVER
repair
leaking
connections
with sealant
of any
kind, Replace
o-ring
or seal.
Pump
Maintenance
Changing Pump OH
Change oil every 50 hours or once yeady, whichever
occurs first.
NOTE: You must purchase an approved bottle of
pump oil by calling 1-800-366-PART
or online at
wv,A,u.sears.com.
Change pump oilas follows:
1.
Drain engine oil and fuel from pressure washer.
2.
Use a 8mm allen wrench to remove black pump
oil cap between high pressure outlet and garden
hose inlet.
Oil Cap
3.
Tilt pressure washer to drain oil into an approved
container until it drips slowly from pump.
4.
Tilt pressure washer in opposite direction and
empty premeasured pump oil bottle into same
opening (a small funnel may be helpful).
5.
Install black pump oil cap and tighten firmly.
6.
Set pressure washer in upright position. Add fuel
and engine oil.
ENGINE MAINTENANCE
WARNING
WHEN
ADJUSTING
OR MAKING
REPAIRS
TO YOUR
PRESSURE
WASHER
* Disconnect
the spark
plug wire from the spark
plug and
place the wire where
it cannot
contact
spark
plug.
WHEN
TESTING
FOR ENGINE
SPARK
Use approved
spark plug tester,
DO NOT check
for spark
with spark
plug removed.
Checking
Oil Level
Oil level should be checked prior to each use or at
least every 5 hours of operation. Keep oil level
maintained.
Changing
Oil
Change engine oil after the first 5 hours and every
50 hours thereafter. If you are using your pressure
washer under extremely dirty or dusty conditions, or in
extremely hot weather, change oil more often.
CAUTION
Used
motor oil has been
shown
to cause
skin cancer
in
certain laboratory animals,
Thoroughly
wash
exposed areas with soap and water.
KEEP OUT OF REACH OF CHILDREN.
DON'T POLLUTE. CONSERVE
RESOURCES.
RETURN USED OiL TO
COLLECTION
CENTERS.
Change oil while engine is still warm from running, as
follows:
1.
Disconnect spark plug wire and keep it away from
spark plug.
2.
Place a suitable container below engine to catch
used oil. Remove dipstick, drain plug and washer.
3.
Allow oil to drain completely. Reinstall drain plug
and washer. Tighten drain plug securely.
16
Tabla de contenido
