Craftsman 580.753010 Instrucciones De Uso página 10

10.Pullchokerodto"Closed"position.
ChokeRod
l
J Closed .J"
NOTE: For a warm engine, be sure the chore rod is in
the "Open" position.
11. Move engine stop switch to "On" position.
\_ 11.f_ "_'__
12. Grasp handle and pull recoil starter lightly until you
feel some resistance, then pull briskly.
WARNING
When starting engine, pull cord slowly until resistance is
felt and then pull rapidly to avoid kickback.
If engine starts and fails to continue to run or if increased
resistance is felt during starting pul! attempts, squeeze
trigger on spray gun.
13. Return recoil starter slowly. DO NOT let rope
"snap back" against starter.
14. When engine starts, slowly move choke rod to
"Open" position as engine warms. If engine
falters, move choke rod to "Closed" position, then
to "Open" position.
WARNING
DO NOT touch hot surfaces.
Allow equipment to coo! before touching.
The pressure washer must be at least 5 feet from
structures having combustible walls and/or other
combustible materials.
Keep at least 3 feet of clearance on al! sides of pressure
washer for adequate cooling, maintenance and servicing.
In the State of California a spark arrester is required by law
(Section 4442 of the California Public Resources Code).
Other states may have similar laws. Federal laws apply on
federal lands. If you equip the muffler with a spark attester,
it must be maintained in effective working order.
How to Stop Your Cleaning System
1. Let engine idle for two minutes.
2. Move engine switch to "Off" position.
3. Squeeze trigger on spray gun to relieve
trapped pressure in hose to avoid injury.
NOTE: A small amount of water will squirt out when
_ressure is released.
WARNING
.
Keep high pressure hose connected to pump and spray
gun while system is pressurized.
Squeeze trigger on spray gun to relieve trapped
pressure, every time you stop engine. Engage trigger
lock on spray gun.
Engage trigger
lock on spray gun when not in use.
10