Important Safety Instructions; Hazard; Potential Consequence; Prevention - Mi-T-M Corporation 37-1438 Manual Del Operador

WARNING: WHEN USING THIS PRODUCT, PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE FOLLOWING.
READ ALL SAFETY WARNINGS BEFORE USING PRESSURE WASHER

HAZARD

RISK OF EXPLOSION OR FIRE Serious injury or death may occur
4

IMPORTANT SAFETY INSTRUCTIONS

POTENTIAL CONSEQUENCE

from normal sparks in the multiple
ignition sources or engine/burner
exhaust.
Serious injury or death may occur
as a result of improper fueling.
Serious injury or death may occur
from the battery.

PREVENTION

Always operate pressure washer in a well
ventilated area free of flammable vapors,
combustible dust, gases or other combus-
tible materials.
Do not store the pressure washer near an
open flame or any equipment such as a
stove, furnace, water heater, etc., which
utilizes a pilot light or sparking device.
Do not use this pressure washer to spray
flammable material!
Do not smoke while filling fuel tanks.
Never fill the fuel tanks while the engine is
running or hot. Allow the engine to cool two
minutes before refueling.
Do not refuel indoors or in a poorly venti-
lated area.
Always refuel slowly to avoid the possibility
of spilled fuel which may cause a risk of fire.
Engine Fuel Tank:
If using a Gasoline Engine, refuel with gaso-
line only. Do not use diesel or fuel oil.
Burner Fuel Tank:
When refueling the Burner Fuel Tank, use
No. 1 or No. 2 fuel oil/diesel or kerosene.
Do not use gasoline, crankcase drainings, or
oil containing gasoline or solvents.
Do not operate the unit if gasoline or diesel
fuel is spilled. Wipe the pressure washer
clean and move it away from the spill. Avoid
creating any ignition until the gasoline or
diesel fuel has evaporated.
When the battery is being activated, hydro-
gen and oxygen gases in the battery are
extremely explosive. Keep open sparks and
flames away from the battery at all times,
especially when charging the battery.
Be certain to disconnect the battery ground
terminal before servicing. When discon-
necting the cable from the battery, start with
the negative terminal, and when connecting
them, start with the positive cable.
When charging the battery, remove the bat-
tery vent plugs.
Use only a voltmeter or hydrometer to check
a battery charge.
DO NOT jump start the battery unless both
batteries are of equal voltage and amper-
age.
Operator's Manual