Mi-T-M Corporation 37-1438 Manual Del Operador página 28

(8) Throughout the engine warranty period stated above, Mi-T-M will maintain a supply of warranted parts sufficient to meet
the expected demand for such parts.
(9) Any replacement part may be used in the performance of any warranty maintenance or repairs and must be provided
without charge to the owner. Such use will not reduce the warranty obligations of Mi-T-M.
(10) Add-on or modified parts that are not exempted by the Air Resources Board may not be used. The use of any non-
exempted add-on or modified parts by the ultimate purchaser will be grounds for disallowing a warranty claims. Mi-T-M will
not be liable to warrant failures of warranted parts caused by the use of a non-exempted add-on or modified part.
(c) WARRANTED PARTS:
The repair or replacement of any warranted part otherwise eligible for warranty coverage may be excluded from such
warranty coverage if Mi-T-M demonstrates that the engine has been abused, neglected, or improperly maintained, and that
such abuse , neglect ,or improper maintenance was the direct cause of the need for repair or replacement of the part. That
notwithstanding, any adjustment of a component that has a factory installed, and properly operating, adjustment limiting
device is still eligible for warranty coverage. The following emissions warranty parts list are covered.
(1) Fuel Metering System
(A) Carburetor and internal parts (and/or pressure regulator or fuel injection system).
(B) Air/fuel ratio feedback and control system, if applicable.
(C) Cold start enrichment system, if applicable.
(D) Regulator assy (gaseous fuel, if applicable)
(2) Air Induction System
(A) Intake manifold, if applicable
(B) Air filter.
(C) Controlled hot air intake system.
(3) Ignition System
(A) Spark plugs.
(B) Magneto or electronic ignition system.
(C) Spark advance/retard system, if applicable.
(4) Exhaust manifold, if applicable (5) Evaporation System
(A) Fuel line
(B) Fuel line fittings
(C) Fuel Tank and Cap
(D) Carbon Canisters and Mounting Brackets
(6) Exhaust Gas Recirculation (EGR) System
(A) EGR valve body, and carburetor spacer if applicable.
(B) EGR rate feedback and control system.
(7) Air Injection System
(A) Air pump or pulse valve.
(B) Valves affecting distribution of flow.
(C) Distribution manifold.
(8) Catalyst or Thermal Reactor System
(A) Catalytic converter.
(B) Thermal reactor.
(C) Exhaust manifold.
(9) Particulate Controls
(A) Traps, filters, precipitators, and any other device used to capture particulate
emissions.
(10) Miscellaneous Items Used in Above Systems
(A) Electronic controls.
(B) Vacuum, temperature, and time sensitive valves and switches.
(C) Hoses, belts, connectors, and assemblies.
28 Operator's Manual