Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EMPTYING THE DEBRIS PAIL
(VX475C, VX550C & VX1000C)
Your power unit has a permanent filter that is self cleaning
under normal conditions. The filter protects the motor and
stops small dirt particles from escaping to the outside of the
power unit. The filter cleans itself by moving up when the
power unit starts, and dropping down when the unit is turned
off. The filter can be removed by means of a pull-tab for
cleaning if desired. Be sure to reinstall properly. Correct
placement is critical to insure proper protection for the
motor.
1. Release both carry handles on side of the unit by pulling
out and then pushing up. (FIGURE 14). Holding the pail
by the handles, lower it from unit (FIGURE 15).
2. Carry pail to trash receptacle and empty.
3. Reattach pail using handles.
4. Close door and push Reset button on control panel. Light
on control panel will change to green on the VX550 &
VX1000.
CLEANING THE INTERNAL
FILTER
When emptying the debris bucket, it is recommended to
clear any dust and dirt that may have accumulated on the
internal filter media. Simply open the direct door, reach in
and tap the top of
the internal filter
(FIGURE
16).
This will release
any loose debris
into the pail. You
may empty the
pail again at this
point but it is not
necessary
as
any amounts of
dirt and dust will
be minimal.
FIGURE 16
FIGURE 14
FIGURE 15
Utility valve (circled in FIGURE 15), next to power unit, can
be used to service area around where power unit is
installed.
7
Tabla de contenido
