Careful Handling And Use Of Batteries; Intended Use; Lithium­ion Battery Status Display; Items Supplied - Hilti NCR 060 II-A22 Manual De Instrucciones Original

▶ Do not operate the tool when exposed to heavy rainfall or under water.
Power tool use and care
▶ After approx. 50 consecutive crimping operations, switch the power tool off and allow it to cool down for
about 15 minutes. Overheating can lead to damage to the power tool.

2.3 Careful handling and use of batteries

▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not take apart, squash or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not attempt to charge or continue to use damaged batteries.
▶ If the battery is too hot to touch, it may be defective. In this case, place the power tool in a non-flammable
location, well away from flammable materials, where it can be kept under observation and left to cool
down. Contact Hilti Service after the battery has cooled down.
3 Description
3.1 Product overview 1
Crimping / pressing head
@
Piston reset slider for use in case of fault or
;
emergency
Servicing and fault indicator (red LED)
=
Battery release button
%
Battery
&

3.2 Intended use

The product described is a cordless electro-hydraulic crimping tool. It is designed for crimping connectors
made of copper (Cu) or aluminum (Al). This hand-held power tool may not be clamped in a fixed position
(e.g. in a vice) for use as a stationary device.
This electro-hydraulic crimping tool may not be exposed to heavy rain or used under water.
Before use of the power tool, all live cables or other items carrying electric voltage within the area in which
the user is working must be switched off. If this is not possible, the corresponding safety precautions for
working in the proximity of live cables or equipment must be implemented and observed.
▶ Use only Hilti Li­ion batteries of the B 18 and B 22 series with this product.
3.3 Lithium­ion battery status display
The charge status of the Li-ion battery and malfunctions of the power tool are indicated by the display on
the Li­ion battery. The charge status of the Li­ion battery is displayed after pressing one of the two battery
release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
Note
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the battery display LEDs blink, please observe the instructions
given in the Troubleshooting section.

3.4 Items supplied

Crimping tool, operating instructions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com.
4 English
Printed: 27.07.2017 | Doc-Nr: PUB / 5365804 / 000 / 00
Slot on both sides, for attaching the Hilti
(
retaining strap
White LED to illuminate the working area
)
Control switch
+
Crimping / pressing ram (stepped)
§
Pivoting bar to open the tool head
/
Lever to lock/unlock the tool head
:
Meaning
• Charge status: 75 % to 100 %
• Charge status: 50 % to 75 %
• Charge status: 25 % to 50 %
• Charge status: 10 % to 25 %
• Charge status: < 10 %