Bosch GLM Professional 50-27 CG Manual Original página 45

To switch on the laser beam, briefly press the measuring button (5) [ ].
To measure, briefly press the measuring button (5) [ ]. The measured value will be
shown at the bottom of the display.
Repeat the above steps for each subsequent measurement. The last
measured value is at the bottom of the display, the penultimate meas-
7.620 m
ured value is above it, and so on.
0.0°
8.890 m
10.160 m
11.430 m
Continuous measurement
In continuous measurement mode, the measuring tool can be moved relative to the tar-
get, during which the measured value will be updated approx. every half a second. You
can, for example, move a desired distance away from a wall while reading off the current
distance at all times.
Select continuous measurement . Select one of the following functions:
– Min/max: The smallest and largest measured value are permanently shown on the dis-
play (see figure J).
– Large numbers: The measured value is displayed in an enlarged format for better
legibility (see figure K).
– Tape measure: The distance will be displayed visually, as with a tape measure (see
figure L). Note: The distance from the marking is shown in the display in the tape
measure function. The reference is not the edge of the measuring tool.
To switch on the laser beam, briefly press the measuring button (5) [ ].
Move the measuring tool until the required distance is shown at the bottom of the dis-
play.
Briefly pressing the measuring button (5) [ ] will interrupt the con-
tinuous measurement. The current measured value will be shown at
the bottom of the display. Pressing the measuring button (5) [ ]
-64°
once more will start the continuous measurement again.
Continuous measurement automatically switches off after four
11.623 m
minutes.
Area measurement
Select the area measurement mode
Bosch Power Tools
.
1 609 92A 4ZJ | (14.10.2020)
English | 45