Cascade F Serie Instrucciones De Instalación página 4

T
RUCK REQUIREMENTS
Truck Relief Setting
25F, 38F (Rotate Circuit). 45-160F
2000 psi (138 bar) Recommended
2300 psi (160 bar) Maximum
38F (Clamp Circuit)
2300 psi (159 bar) Recommended
2600 psi (179 bar) Maximum
Truck Flow Volume
25F
38F Clamp
Rotate
45F, 60F, 66F
77F, 90F, 100F,
120F
130F, 150F,
160F
➀ Cascade Roll Clamps are compatible with SAE 10W
petroleum base hydraulic fluid meeting Mil. Spec. MIL-0-5606
or MIL-0-2104B. Use of synthetic or aqueous base hydraulic
fluid is not recommended. If fire resistant hydraulic fluid is
required, special seals must be used. Contact Cascade.
➁ Flow less than recommended will result in a rotate speed less
than 2 RPM.
➂ Flow greater than maximum can result in excessive heating,
reduced system performance and short hydraulic system life.
Carriage Mount Dimension (A)
A
Class II
Class III
Class IV
Auxiliary Valve Functions
Check for compliance with ANSI (ISO) standards:
2
➀
Recommended
➁
Min.
5 GPM 7 GPM
(19 L/min.) (26 L/min.)
5 GPM 10 GPM
(19 L/min.) (38 L/min.)
5 GPM 12 GPM
(19 L/min.) (45 L/min.)
5 GPM 7 GPM
(19 L/min.) (26 L/min.)
10 GPM 15 GPM
(38 L/min.) (57 L/min.)
15 GPM 20 GPM
(57 L/min.) (76 L/min.)
Minimum
14.94 in. (380.0 mm)
18.68 in. (474.5 mm)
23.44 in. (595.5 mm)
➂
Max.
10 GPM
(38 L/min.)
12 GPM
(45 L/min.)
15 GPM
(57 L/min.)
10 GPM
(38 L/min.)
20 GPM
(76 L/min.)
25 GPM
(95 L/min.)
ITA (ISO)
Maximum
15.00 in. (381.0 mm)
18.74 in. (476.0 mm)
23.50 in. (597.0 mm)
Hoist Down
GA0082.eps
Hoist up
WARNING: Rated capacity of the truck/
attachment combination is a responsibility
of the original truck manufacturer and may
be less than that shown on the attachment
nameplate. Consult the truck nameplate.
Clean and inspect carriage bars
for damage and smoothness.
Repair any protruding welds or
damaged notches.
Tilt Forward Rotate CCW
Release
Clamp
Tilt Back
Rotate CW
781578-R3 EN
GA0369.eps