Removing/Installing/Storing The Metal Handle; Lowering Handle For Storage - Workshop WS1100CA0 Manual Del Usuario

SP6854-1 WS1100CA0 Workshop:SP6439-3_ES.qxd 10/14/13 2:44 PM Page 6
REMOVING/INSTALLING/STORING
Your metal handle comes packaged in the
dust drum. You must remove the metal
handle from the dust drum and install the
handle in the correct direction, bent area
facing away from the back of the Vac,
before continuing. (Also remove the 8"
wheel and set aside for installation).
Installing Handle
Press and hold release buttons while
installing handle into handle receptacles
in drum (See illustration).
NOTE: An audible snap of release
buttons indicates successful engagement
of handle.

Lowering Handle for Storage

To store Wet/Dry Vac, press and hold
release buttons while firmly sliding handle
down.
Removing Handle
Press and hold release buttons, as
shown. While firmly pushing in release
buttons, pull handle upwards to remove.
THE METAL HANDLE
6
Latch (2)
Pull Down and
Slide Dust Drum
Out of Wet/Dry
Vac Unit
Handle
Press and
Hold Release
Buttons
Release
Handle
Button (2)
Receptacle (2)