Maintenance And Troubleshooting - Renault 3998 Manual Del Usario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 62
User manual
5 - PERSONAL PIN CODE
The PIN code should be personalised. The system is delivered
with the code 1111 and it must be replaced by a four digits code
without the number '0' .
To program the system with your own four digit PIN code, disarm
the system, then proceed as follows:
• Open a door
• Turn the ignition On.
Keep the control panel button and button 'A' of the radio control
simultaneously pressed until a blink of the turn indicators occurs,
this indicates that you can now program a new PIN code.
• Push the button on the control panel for the number of times
corresponding to the first digit of the new PIN code.
The led will blink everytime you press the button, a longer blink
will confirm that the right PIN code digit has been input.
Proceed in the same way for the further 3 digits.
• Turn the ignition OFF at the ackowlegement of the fourth digit.
• Repeat the new PIN code entry.
• If this PIN code is the same as the previous the system will
store it. The storage confirmation is given by a 3 s blink of the
turn indicators and of the LED.
To exit the program at any time, close the opened door and the
old PIN will not be modified.
GB
18
6 - MAINTENANCE AND TROUBLE SHOOTING
6.1 - The radio control does not disarm the system
(Re-synchronization procedure)
If the radio control battery is not flat and the radio control doesn't
work, proceed as follows keeping at a distance of 1 meter from
the driver's window:
A) Press both buttons on the radio control until the LED on it
goes out. Release them (the LED will come on permanently).
B) Press button 'A' of the radio control, the LED will flash. The
re-synchronization procedure has been completed.
C) Press button 'A' of the radio control again to verify that the
system operates correctly.
If the radio control doesn't work, refer to the emergency override
(see chapter 4).
6.2 - Radio control battery low
When the radio control battery becomes low, the radio control
LED will blink in an irregular way or only once instead of
permanently until the button is released. Replace the battery.
1. To change the battery, open the radio control as indicated in
the figure, levering in the zone marked "OPEN".
2. Remove the battery as indicated.
3. Wait for about 10 s.
4. Connect the new battery. Only touch it on the sides. Remember
to comply with the polarity indication, as shown in the figure.
Tabla de contenido
loading

Tabla de contenido