Powermate PWLE0799.1 Manual Del Usuario página 9

Bordeadora 3.1 pies libras, 4 ciclos
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Engine Preparation
• Save all instructions
B
How to Check Oil Level and Fill to Proper Level
WARNING
Before checking oil, make sure engine is off, and spark
plug wire has been disconnected from spark plug .
1 . Place the edger on a level surface and make sure the
adjustable wheel heights are set so the main frame of the
edger is level . (See Figure 3)
2. Remove the oil fill cap/dipstick and wipe clean with cloth.
(See Figure 3)
3. Insert dipstick into fill spout but do NOT screw in.
Remove dipstick and check oil level .
4 . When oil level is full, the oil will be at upper limit on dip
stick . If oil level is near or below the lower limit, oil must
be added . (See Figure 4)
5 . Add oil slowly until the oil level reaches the upper limit of
the dipstick . Use a funnel or nozzle to reduce spillage .
NOTICE
Frequently check oil level while filling . DO NOT OVERFILL .
DO NOT UNDER-FILL . Running engine at improper oil
level will seriously damage engine .
6 . Replace and tighten dipstick .
7 . Clean up any spilled oil .
C
Fuel
WARNING
Gasoline is extremely flammable and vapors can
explode if ignited. Handle with care.
Use fresh unleaded gasoline with an octane rating of 87
or higher . Do not use gasoline containing more than 10%
ethanol . Use of non-ethanol fuel is best . We recommend
the continuous use of a fuel additive /stabilizer to
counteract the effects of ethanol . These additives also
prolong the shelf life of gasoline .
NOTICE
Using incorrect fuel type or contaminated fuel will cause
serious engine damage .
NOTE: Fuel tank capacity is approximately 1 .69 qt (1 .6L)
Questions? Call Toll Free at 1-800-737-2112
(Continued)
EN - 9
Adjustable Wheels
Upper Limit
Lower Limit
How to Fill Engine with Fuel
WARNING
Turn engine off and let engine cool for several minutes
before removing the fuel cap or adding fuel . Never fill fuel
tank indoors . Do not smoke while adding fuel .
1 . Clean surface around fuel tank cap to prevent
contamination . (See Figure 3)
2 . Loosen fuel cap slowly . After removing cap, place on a
clean surface .
3 . Pour fuel into the tank . Use care to avoid spillage .
NOTE: DO NOT overfill fuel . Allow space for the fuel to
expand due to heat from engine and/or sun .
4 . Before replacing the fuel cap, inspect and clean the fuel
cap seal .
5 . Replace the fuel cap and securely hand-tighten .
6 . Clean up any spilled fuel .
Copyright © 2019 MAT Engine Technologies, LLC
Fuel Tank Cap
Oil Fill Cap/Dipstick
Figure 3
Oil Fill Cap/
Dipstick
Figure 4
Tabla de contenido
loading

Tabla de contenido