Powermate PWLE0799.1 Manual Del Usuario página 11

Operation
(Continued)
• Save all instructions
B
How to Start Engine (Continued)
7 . After the engine starts, wait 2-5 seconds and rotate the
choke back to the RUN position .
8 . If engine fails to start after 5 or 6 more attempts, see
instructions in the TROUBLESHOOTING CHART .
C
How to Stop the Edger
Release the start lever (See Figure 6) . This will ground out
the engine through the ground wire, causing the engine
to stop .
D
How to Change the Edger Cutting Depth
Move the Depth Control Lever forward to increase the
depth . (See Figure 7)
NOTE: There are 5 cutting depth settings from
approximately ground level to 2.5" (63 mm) deep.
NOTICE
Do not overload the edger capacity by attempting to edge
too deep at too fast a rate . To edge at deeper settings,
make multiple passes, first cutting at shallow depths .
E
How to Change the Blade Angle for a Beveled Edge
The blade can be adjusted 15 degrees from vertical (both
directions) to provide a beveled cut, which will cut the
grass further away from the sidewalk or driveway, reducing
the need to edge as often . Using the beveled edge at a
deep depth will cut a trench into the ground .
1 . Stop the engine .
2 . Disconnect the spark plug wire from the spark plug .
3 . Disengage the index lever (See Figure 8) . Move the
index lever to the desired notch (15, 0 or -15 degrees) .
4 . Before you start the engine, line up the edger as if you
were going to bevel cut .
NOTICE
Do not overload the edger capacity by attempting to edge
too deep at too fast a rate . To edge at deeper settings,
make multiple passes, first cutting at shallow depths .
Questions? Call Toll Free at 1-800-737-2112
WARNING
Keep hands, feet, hair, and loose clothing away from any
moving parts . Avoid touching muffler and surrounding areas
temperatures can exceed 150 degrees . Keep all safety
devices and shields in place .
WARNING
The ground wire terminals must be securely connected for
the Start Lever to function . Refer to the "How To
Assemble The Handle" section on page 7 .
Start Position
Full Depth
EN - 11 Copyright © 2019 MAT Engine Technologies, LLC
Depth Control
Lever
Forward
Depth Selector
Lever
Plate
Figure 7
Figure 8