Pride Mobility Travel Scooter Serie Manual De Instrucciones página 11

I I . Y O U R T R A V E L S C O O T E R
Charger Power Cord Receptacle
The 3-pin end of the charger power cord plugs into this receptacle. See figures 7 and 8.
TILLER CONSOLE FUSE (IF EQUIPPED)
The fuse located under the battery pack protects the tiller console electronics. See figure 6. In the event
any component of the tiller console is not responding, check this fuse. See VII. "Basic Troubleshooting"
for fuse replacement instructions.
OFF-BOARD BATTERY CHARGER
The off-board battery charger, when plugged into the charger power cord receptacle and a standard
electrical outlet, charges the Travel Scooter's batteries. See figure 9.
Figure 7. Charger Power
Receptacle (Tiller Mounted)
SECUREMENT POINTS
Always secure the Travel Scooter in a forward-facing position in the vehicle. Attach the four tie-down
straps to the designated securement points. See figure 10. Tighten the straps to sufficiently remove all
slack. Never attach tie-downs to adjustable, moving, or removable parts of the Travel Scooter such as
armrests, shrouds, and wheels. These items should be removed. Position the anchor points for the rear tie-
down straps directly behind the rear securement points on the Travel Scooter. The front tie-down straps
should anchor to floor points that are spaced wider than the Travel Scooter to provide increased lateral
stability.
WARNING! Ensure Travel Scooters are properly secured to the motor vehicle during
transport. Scooters that are not properly secured can become a hazard to the user and
to other vehicle passengers in the event of a crash, sudden stopping, or swerving, as the
Travel Scooter could tip or slide out of place.
Travel Scooter Series
Cord Figure 8. Charger
Receptacle (Battery Pack)
Power Cord Figure 9. Off-board Battery Charger
XLR
11