Faber INCA LUX Serie Instrucciones De Instalación página 36

BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED AS FOLLOWS:
La campana se puede instalar directamente en la parte inferior de la
unidad de pared (mínimo 24 "-30" desde la superficie de cocción).
INSTALLATION
Crear una abertura en la parte inferior de la unidad de pared,
como se muestra.
nectors.
• Disconnect the wires to the Commands at the connectors.
• Disconnect the wires to the Light at the con-
nectors.
underside of the wall unit (Minimum 650 mm
from the Cooker Hob).
• The Hood can be installed directly on the
as shown.
underside of the wall unit (Minimum 650 mm
from the Cooker Hob).
• Create an opening in the bottom of the wall unit,
place.
as shown.
• Insert the hood until the side supports snap into
place.
Vf
underneath the hood. • Fasten using the 10 screws 12a provided.
• Lock in position by tightening the screws Vf from
underneath the hood.
Abra el panel de la tapa del filtro girando la perilla específica.
• Open the suction panel by turning the specific knob.
Desconecte el panel de la cobertura de la campana deslizando las
fixing pin lever.
• Disconnect the panel from the hood canopy by sliding the
palancas de los pasadores de fijación.
fixing pin lever.
• Remove grease filters.
Retire los filtros de grasa
y déjelos aparte.
• Screw the Frame into place
using the 6 screws 12f, re-
using the 6 screws 12f, re-
connect the wires to the
connect the wires to the
Commands and Light, re-
place the metal grease filter
Commands and Light, re-
and the Panel.
place the metal grease filter
Atornille el marco en su lugar con los 6 tornillos
and the Panel.
12f(1/8"x5/16" torx), vuelva a conectar los
alambres al conector y el cable de tierra eléctrico
(Amarillo/Verde) retirado previamente. Vuelva a
colocar el filtro de grasa de metal y el panel.
7 7
EN
EN
36
INSTALLATION
BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED A
Fitting the Hood canopy
• Disconnect the wires to the Commands at the connectors.
BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED AS FOLLOWS:
• Disconnect the wires to the Light at the con-
nectors.
• The Hood can be installed directly on the
underside of the wall unit (Minimum 650 mm
from the Cooker Hob).
• Create an opening in the bottom of the wall unit,
as shown.
Inserte la campana hasta que los soportes laterales encajen en su lugar.
• Insert the hood until the side supports snap into
Sujete usando los 10 tornillos12aprovistos.
place.
Bloquee la posición apretando los tornillos Vf desde debajo de la campana.
• Fasten using the 10 screws 12a provided.
• Lock in position by tightening the screws Vf from
underneath the hood.
• Open the suction panel by turning the specific knob.
• Disconnect the panel from the hood canopy by sliding the
fixing pin lever.
• Remove grease filters.
• Screw the Frame into place
using the 6 screws 12f, re-
connect the wires to the
Commands and Light, re-
place the metal grease filter
and the Panel.
Fitting the Hood canopy
Fitting the Hood canopy
7 7
7 7
7