Samson Resolv RXA10S Manual Del Usuario página 9

ADDING THE RXA10S TO YOUR MONITOR SYSTEM
Adding an RXA10S subwoofer to extend the low frequency response of your monitor
system can be beneficial when mixing your music. Typically, it is best to set the
subwoofer level to be equal to that of the main speakers.
Because deep-bass frequencies are non-directional, it is difficult for our ears to
locate the sound source, and the precise placement of the subwoofer is not as
critical as the main speakers. The ideal location is between the two main speakers. If
you notice there are frequencies that sound quieter than others, move the subwoofer
slightly to the left or right. You can also try setting the PHASE switch to the 180°
phase setting to see if this provides an improved low frequency response.
If you have active monitors, installation is easy using the RXA10S LINE OUT jacks.
Below is a typical system set-up using the R10s with a mixer and a pair of active
satellite loudspeakers.
To incorporate a subwoofer into your monitor system, connect Left and Right Control
Room outputs of your mixer to the RXA10S line inputs. Then connect the subwoofer's
LINE Outputs to the left and right satellite speakers. Run an audio signal (such as
music from an MP3 player) through your mixer and raise the level to a comfortable
listening volume. Now adjust the LPF control to the desired frequency.
Consult your studio monitors owner's manual for a recommended crossover point.
You can also use your ears by adjusting the LPF control to the frequency that sounds
good to you.
Run an audio signal through your system and raise the level to a comfortable
listening level.
RESOLV RXA10S 10" Active Studio Subwoofer 9