Samson Resolv RXA10S Manual Del Usuario página 7

Rear Panel Callouts
1. SYSTEM VOL – Controls the overall output level for the RXA10S subwoofer and
connected satellites.
2. SUBWOOFER VOL – Controls the output level of the input of the internal power
amplifier.
3. LPF (Hz) EQ – Adjusts the low pass frequency filter of the subwoofer from
80Hz-160Hz. This setting does not affect the signal sent to the THRU outputs.
4. PHASE Switch – Use this switch to set the polarity of the amplified signal. In the
0 setting, there is no change to the signal. When the switch is set to the in 180
setting, the signal's polarity is changed by 180°.
5. LINE IN – Connect a balanced XLR (+4dBU) or unbalanced RCA (-10dBV), line
level signal here.
6. LINE OUT – Balanced XLR or unbalanced RCA stereo line outputs to connect to
satellite speakers. When the subwoofer is active, the outputs send a high-passed
signal. When the subwoofer is muted, the signal is full-range.
7. SUB BYPASS Jack – Used to connect an external switch to activate the internal
mute function.
8. POWER Switch – Use this switch to turn the speakers on and off. When powered
on, the front panel LED will light.
9. AC Inlet – Connect the supplied IEC power cable here.
10. Voltage Switch – Used to select the operating voltage.
NOTE: Be sure to check that the voltage setting and fuse rating are correct for
your country.
RESOLV RXA10S 10" Active Studio Subwoofer
1 2 3
4
7
5
6
9 8
10
7