Pump Connector; J5 - Gauge Connector - Agilent Technologies Turbo-V 301-AG Manual De Istrucciones

Pump Connector

A five-meter long cable is available to connect the controller to the
pump. The following figure shows the controller output connector
configuration where pins:
Figura 4
J5 – Gauge Connector
This connector is available to connect "EyeSys Mini-IMG" gauge with
it's extention cable (see orderable parts table).
The pressure can be read by dispaly or by serial line (win. 224) or by
REMOTE I/O on Programmable Analog Out (in this case the
controller replicates the signal coming from the gauge).
Turbo-V 301-AG Rack Controller User Manual / 87-900-982-01
A-F = pump temperature sensor
B-C-D = 75 Vac 3-phase output to pump motor stator
E = EARTH PROTECTION
Controller-to-Pump Connector
Technical Information
Programmable Analog Output Diagrams
(F)
17
223/294