Surface Burners; When Self-Cleaning Your Oven - Kenmore SELECT CLEAN 665.75822 Guía Para El Uso Y Cuidado

SURFACE BURNERS

PROBLEM
The burner fails to light
The burner flames are
uneven
The burner flames lift off
the ports, are yellow, or
are noisy when turned off
The burner makes a
popping noise when on

WHEN SELF-CLEANING YOUR OVEN

PROBLEM
The Self-Cleaning cycle
will not work
CAUSE/SOLUTION
•
The control knob is not set correctly. Push in the control knobs before turning
them. Make sure the control knob is turned to the LITE position. (See p. 7.)
•
A household fuse has blown or a circuit breaker has been tripped.
•
The burner ports may be clogged. Clean them with a straight pin. (See p. 33.)
•
The burner ports may be clogged. Clean them with a straight pin. (See p. 33.)
•
The burner caps may not be positioned properly. (See p. 33.)
•
The burner needs cleaning. (See pp. 32, 33.)
•
The burner may be damaged. Contact a Sears Service Center to check
the burner.
•
If propane gas is being used, the range may have been converted
improperly. Contact a Sears Service Center.
•
The burner is wet from washing. Let it dry.
CAUSE/SOLUTION
•
START/ENTER has not been pressed.
•
A delay start has been set. Wait for the start time to be reached or cancel
and reset the control.
•
The door is not closed all the way.
TROUBLESHOOTING
37