Tabla de contenido
The volume of the source is too high/low during the navigation interruption of the car system.
• The volume is not appropriately adjusted.
- During navigation voice interruption, adjust the volume of the current listening source using the commander. The next time the
navigation voice interrupts, the volume will match the adjusted source.
When the navigation voice of the car system interrupts, the volume of the source changes.
• The volume of the source was adjusted during a navigation voice interruption.
- During a navigation voice interruption, adjust the desired volume using the commander.
If the volume of the source is adjusted during a navigation voice interruption, its volume is stored, and the volume of the source is
adjusted at the next time navigation voice interruption.
Navigation interruption of the car system is not cancelled.
• Navigation voice is output.
- Navigation interruption cannot be cancelled on the unit. 5 seconds after you have operated the navigation and finished the guidance,
interruption is cancelled, and the volume of the source returns to its previously adjusted level.
The volume of the telephone interruption of the car system is too high/low.
• The volume is not appropriately adjusted.
- During the telephone interruption, adjust the volume appropriately using the commander. At the next telephone interruption, the
volume will be adjusted automatically to that level. (Concerning the volume display, though the volume of the source is displayed,
the volume of the telephone interruption is not displayed.)
Telephone interruption of the car system is not cancelled.
• Telephone voice is output.
- If the volume of the telephone is higher than the interruption detection level (FACT SYS DET), the telephone voice interrupts again
even when interruption is cancelled. Press SOURCE/POWER after hanging up, and cancel the telephone interruption.
Although the source screen is displayed, sound is not output.
• The telephone is interrupting.
- 1) Make sure that the commander blinks quickly, and hang up.
- 2) Press SOURCE/POWER, and cancel the telephone interruption.
Operation cannot be performed on the unit.
• The telephone is interrupting.
- When the speaker input mode (FACT SYS SET) is set to INT or BOTH, or the voice interruption type (F.SYS MIX TYP) is set to
MUTE, the telephone will interrupt if the audio of the car system is turned on in a source other than FACTORY SYS.
Press SOURCE/POWER after the audio of the car system is turned off, and cancel the telephone interruption. Refer to "Setting the
Speaker Input Mode" (page 16) and "Setting the Interrupt Type of the Speaker Input Voice" (page 17).
Tabla de contenido
