Electrical Safety; Environmental Protection; Connecting To Earth; Starting The Engine - Matrix PG 3100 Traducción Del Manual Original

9 Oil shortage cut-out
10 On/Off switch
11 Choke lever
12 Pull cord
13 Petrol cock
14 Wheels
15 Carry handle
16 Transport handles
17 Air filter set
18 Spark plug
19 Spark plug wrench set
20 Wheel assembling set
21 Spanner
6. Before putting the machine into
operation
6.1 Wheel assembly (B5-B6)
1. First place one end of the bolt (item 20)
through the
hole in the frame and secure it with a nut and
washer.
2. Place the wheel cover and secure it via clip as
designed on the inner side of cover.
3. Assemble the left side wheel with same
prodcedure as above.
6.2 Rubber feet assembly (B7)
Hold the foot against the frame as shown. First
place the bolt through the hole in the frame and
the hole in the foot and secure it with a nut. Then
secure other three bolts and nuts with same
procedure.

6.3 Electrical safety

- Electric supply cables and connected equipment
must be in perfect condition.
- The generator is to be operated only with
equipment whose voltage specifications conform
to the generator's output voltage.
- Never connect the generator to the power
supply (socket-outlet).
- Keep the cable length to the consumer as short
as possible.

6.4 Environmental protection

- Dispose of soiled maintenance material and
operating materials at the appropriate collection
point.
- Recycle packaging material, metal and plastics.

6.5 Connecting to earth

The housing is allowed to be connected to
earth in order to discharge static electricity. To
do this, connect one end of a cable to the earth
connection (4) on the generator and the other
end to an external earth (for example an earthing
rod).
7. Operation
Important!
You must fill up with engine oil and fuel before
you can start the engine.
- Check the fuel level and top it up if necessary.
- Make sure that the generator has sufficient
ventilation.
- Make sure that the ignition cable is secured to
the spark plug.
- Inspect the immediate vicinity of the generator.
- Disconnect any electrical equipment which may
already be connected to the generator.

7.1 Starting the engine

- Do not connect the power tool before starting
the motor.
- Open the petrol cock (13) by turning it down.
- Move the ON/OFF switch (10) to position "I".
- Move the choke lever (11) to position IØI.
- Start the engine with the reversing starter (12)
by pulling the handle forcefully. If the engine
does not start, pull the handle again.
- Push the choke lever (11) back again after the
engine has started.
15