Electrical Safety; Environmental Protection; Connecting To Earth; Connecting Consumers To The Generator - Matrix PG 5600-1 Traducción Del Manual Original

and fixing it with knob (item 32). Then place the
bolt with a gasket through the hole in the frame
and the push bar. And secure it with a washer and
a nut, as shown in Figure 7-8).
The user can adjust the position of carry handle
for removing the machine via release the knob
(item 32) and rotated the carry handle (item 18)
to horizontal position.

6.4 Electrical safety

- Electric supply cables and connected equipment
must be in perfect condition.
- The generator is to be operated only with
equipment whose voltage specifications conform
to the generator's output voltage.
- Never connect the generator to the power
supply (socket-outlet).
- Keep the cable length to the consumer as short
as possible.

6.5 Environmental protection

- Dispose of soiled maintenance material and
operating materials at the appropriate collection
point.
- Recycle packaging material, metal and plastics.

6.6 Connecting to earth

The housing is allowed to be connected to
earth in order to discharge static electricity. To
do this, connect one end of a cable to the earth
connection (6) on the generator and the other
end to an external earth (for example an earthing
rod).
7. Operation
Important!
You must fill up with engine oil (see Fig 9) and
fuel before you can start the engine.
- Check the fuel level and top it up if necessary.
- Make sure that the generator has sufficient
ventilation.
- Make sure that the ignition cable is secured to
the spark plug.
- Inspect the immediate vicinity of the generator.
- Disconnect any electrical equipment which may
already be connected to the generator.
7.1 Starting the engine (starter rope)
- Do not connect the power tool before starting
the motor.
- Open the petrol cock (16) by turning it down.
- Move the Electro starter(15) to position "I".
- Move the choke lever (13) to position IØI.
- Start the engine with the pull cord (14) by
pulling the handle forcefully. If the engine does
not start, pull the handle again.
- Push the choke lever (13) back again after the
engine has started.
Important!
When starting with the pull cord, the motor may
recoil suddenly as it starts up, resulting in hand
injuries. Wear protective gloves when starting the
equipment.
7.2 Starting the engine (electro starter)
- Check the battery voltage. The voltage should
be not less than 12V. If the battery voltage is less
than 12V, charge the battery accordingly before
operating the generator.
- Do not connect the power tool before starting
the motor.
- Move the choke lever (13) to position IØI.
- Open the petrol cock (16) by turning it down.
- Turn the electric starter (15) with the key to the
"START" position until the motor has started.
- Push the choke lever (13) back again after the
engine has started.

7.3 Connecting consumers to the generator

Connect the equipment you want to use to the
socket-outlets (3/4)
Important:
- These sockets may be loaded continuously
70