Troubleshooting - Black and Decker SL3WAKB Manual De Instrucciones

controls and Functions
1
2
1. 3 watt LED bulb
2. Rubber Bezel
3. On/Off Trigger
4. Low Battery Voltage LED Indicator
5. End Cap
6. Trigger Lock
powEr SUpply
The unit is powered by four "AA" alkaline dry cell batteries (may be sold separately). You must install
the batteries (following the directions in the next paragraph) before first use and whenever the Low
Battery Voltage LED Indicator flashes red to indicate that battery power is low.
Unscrew the end cap on the back of the unit (counter-clockwise) and remove it. Insert batteries as
described in compartment, observing the cautions that follow. Replace the end cap on the unit by first
aligning the two grooves of end cap to fit over the two ribs in the battery compartment; then screwing
the end cap in a clockwise direction to secure. Do NOT overtighten.
Note:
Use only "AA" alkaline dry cell batteries in this unit.
SL3WAKB_ManualENSP_120110.indd 4-5
4
5
3
7
6
8
9 10
7. Pistol Grip Handle
8 Battery Compartment containing four (4)
"AA" alkaline dry cell batteries (may be sold
separately)
9. Ribs (align and fit into the two corresponding
grooves in the end cap)
10. End Cap detail showing grooves
4
CAUTIONS
• When replacing the "AA" alkaline dry cell batteries: DO NOT mix old and new batteries. Always
insert batteries correctly with regard to polarity (+ and –), marked on the battery and the battery
compartment. Remove dead batteries immediately and dispose of per local codes.
• Follow all warnings regarding batteries in the Important Safety Instructions section of this manual.
opEratiNg iNStrUctioNS
operating the Spotlight
The On/Off Trigger turns the unit on and off, and is also used to choose either the high or low
brightness setting.
1. Press and hold the On/Off Trigger once to use the spotlight in its high (brightest) setting.
2. Release the On/Off Trigger to turn the unit off.
1. Press the On/Off Trigger twice, then hold the Trigger, to use the spotlight in its low (dimmest)
setting.
2. Release the On/Off Trigger to turn the unit off.
Using the trigger lock
To lock the spotlight in the on position, press the On/Off Trigger once (brightest setting) or twice
(dimmest setting) and hold, then press the Trigger Lock to the locked position. The spotlight will stay
on until the Trigger Lock is pressed to the unlocked position and the On/Off Trigger is released.
If the On/Off Trigger is released when the Trigger Lock is pressed to the locked position, the spotlight
will be locked in the off position. To turn the spotlight on again, press the Trigger Lock to the
unlocked position before pressing the On/Off Trigger.

troUblEShootiNg

Solution
Problem
1. The End Cap may be loose. Screw the End Cap clockwise to
Light will not operate
secure. Do not over-tighten.
2. The batteries may be completely discharged. Replace the
batteries following the directions given in this manual.
3. If the light does not operate after replacing the batteries
and tightening the back cover, contact manufacturer at
(877) 571-2391.
carE aND MaiNtENaNcE
Never submerge the unit in liquids of any kind. If the unit gets dirty, gently clean the outer surfaces of
the closed body casing with a soft cloth moistened with a mild solution of water and detergent.
Except for the batteries, there are no user-serviceable parts inside. Contact the manufacturer if any
components have become worn or broken.
Safe battery Disposal
Refer to the Safety Warnings in the front of this Instruction Manual when selecting and replacing
batteries. Always dispose of used batteries properly.
WARNING: TO REDUCE THE RISK OF INJURY/EXPLOSION:
• Do not dispose of batteries in fire as this may result in an explosion.
• Do not expose the unit containing batteries to fire or intense heat as it may explode.
accESSoriES
Recommended accessories for use with your tool are available from your local dealer or authorized
service center. If you need assistance regarding accessories, please contact manufacturer at
1-877-571-2391.
WARNING: The use of any accessory not recommended for use with this appliance could be
hazardous.
SErVicE iNForMatioN
Whether you need technical advice, repair, or genuine factory replacement parts, contact the
manufacturer at 1-877-571-2391.
or
5
12/1/2010 3:46:52 PM