Filling The Jacket; Switch On, Start Of Cooking And Switch Off; Cleaning And Care Of The Appliance - Lotus PI50-78ET Instrucciones De Instalación, Uso Y Mantenimiento

Warning! : The water level in the jacket must be checked each time before lighting.
Warning! : It is advisable to use softened water to fill the jacket!
−
Open the level tap on the front of the appliance.
−
Unscrew the filling cap on the safety valve unit. The latter is on the right of the appliance surface (see
figure "Size of appliance and position of connections ").
−
Fill with softened water (the capacity of the jacket is stated in the paragraph "Technical data").
−
When water flows out of the level tap, close it and screw back on the safety unit cap.
3.2.2. SWITCHING ON, START COOKING AND SWITCHING OFF
−
Fill the vat with hot or cold water, according to need, using the tap that the appliance is equipped with.
−
The appliance has a three-position selector to start cooking functions (see figure "Controls").
−
Here is a list of the procedures for a safe and correct use of the appliance.
Energising the unit:
−
Connect the appliance by turning on the main switch installed before it.
Start of cooking:
−
Turn the selector from position "0" to one of the heating positions according to cooking requirements.
−
The green light turns on automatically.
−
Generally cooking is started with the selector in position "2"; once the vat has reached cooking
temperature, turn the selector to "1" to maintain it.
−
Set the operating thermostat knob on the desired temperature between 40 and 100°C.
−
Heating will start and the orange light will turn on automatically.
−
The orange light will turn off as soon as the set temperature has been reached.
−
To make water boil quickly, turn the knob over the temperature of 100°C.
−
Heating elements operate continuously.
−
By turning the selector from position "2" to "1", it is possible to keep the water boiling and use less
power.
−
Do not use aggressive substances or abrasive detergents when cleaning the stainless steel components.
−
Avoid using metal pads of the steel parts as they may cause rust. For the same reason, avoid contact
with materials containing iron.
−
Do not use sandpaper or abrasive paper for cleaning; in special cases use a powder pumice stone.
−
In case of particularly resistant dirt, it is advisable to use abrasive sponges (e.g. Scotch-Brite).
−
It is advisable to clean the appliance only once it has cooled down.
Manuale d'istruzione per l'installazione, la manutenzione e l'uso
Pentole elettriche PI50-78ET

3.2.1. FILLING THE JACKET

3.3. CLEANING AND CARE OF THE APPLIANCE

05.10.01 pagina
- IT
28