Questions And Answers - DRILL DOCTOR 350X Guia Del Usuario

Ocultar thumbs Ver también para 350X:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Questions and Answers

1. Question:
Why was my drill bit sharpened improperly?
Answer:
The most common cause of improper sharpening is
improper drill bit alignment.
Key causes are:
1. Chuck not pushed all the way into the Sharpening
Port.
2. Drill not aligned in the Alignment Fingers correctly.
4. Chuck is dirty and the bit slipped out of alignment. See
page 17, "Cleaning the Chuck," to correct.
5. Too many rotations of a small-diameter bit results in
incorrect sharpening, and too few on a large bit may
not sharpen enough. See page 11–12, "Drill Bits of Dif-
ferent Sizes."
In order to correct these problems be sure the Chuck is all
the way in the Sharpening Port with the Guides correctly
matched up.
2. Question:
When I aligned the drill bit and sharpened it, why was
no material removed?
Answer:
This happens when the bit is not protruding out of the
Chuck far enough. The Chuck may not have been tightened
enough and the bit may have slipped in the Chuck.
Carefully realign the bit in the Chuck and set its depth in
the Sharpening Port again.
3. Question:
I sharpened the bit. Why will it not cut?
14
www.drilldoctor.com
Tabla de contenido
loading

Este manual también es adecuado para:

27403

Tabla de contenido