Idiomas disponibles
Idiomas disponibles
G
B
P
RELEASE KNOB FOR SER ELECTROBRAKE: ASSEMBLY PROCEDURE
1° - Insert the steering compass (B) into the cable (A), as shown in the
drawing.
2° - Insert the sheated cable (C) along the cable (A).
3° - Insert the compass (D) onto the cable (A) as shown.
4° - Insert part (E) paying attention that part (F) has been completely
screwed.
5° - Insert the compass with the blocking screw (G) against part (F) and
tighten the hexagonal screw with a key n° 7.
6° - Fix part (H) with part (F).
To safely carry out the movement of the rolling gate it is important to
M
AINTENANCE
To be undertaken only by specialized staff after disconnecting power
supply.
Every two years it is advisable to check if the screws of the pulley and the
screw fixing to the shaft are tighten.
OPTIONALS
E
LECTRO-BRAKE
Utilized for all SER versions as a safety system in case of shutter with
damaged springs.
Fed by a motor, equipped with cable, sheath, release knob in case of
black-out.
C
OUPLE OF HALF BEARING OF REDUCTION
Utilized to mount SER motors 20-22-22 S on shafts of smaller diameter.
In nylon.
- Dim. = Ø 42/48
- Dim. = Ø 42/60
- Dim. = Ø 48/60
6-1624000 REV. 09 DEL 05/03/13
-
For the connections and the technical data of the fixtures follow the relevant handbooks.
code 64100200
code 64100203
code 64100204
code 64100205
verify that:
- there are handles on the rolling gate;
- their position does not create dangerous points during the use;
- the manual effort to move the rolling gate must not exceed 225N for
the doors located in private sites and 390N for the doors located
in commercial or industrial sites (values indicated in point 5.3.5 of
EN 12453 standard).
ATTENTION: the activation of the release can cause an incontrollable
movement of the rolling gate in case the latter is not perfectly balanced.
Check that the springs are properly balanced and lubricate the guide with
silicone grease.
C
OMPENSATION FLANGES
They are assembled on the sides of the spring-boxes with smaller
diametre to allow assembly of SER 22 and 22 S.
In iron plate.
Dim. = Ø 220x8
18
18
10
code 64100206
