Tabla de contenido
Assembly Instructions
Hammer
5/16''
T-Nut
3/8'' hole
5/16''
T-Nut
T-nut
Swing
Beam
Bottom Beam Clamp
Swing Hanger Assembly
1. Tap 5/16'' T-nut into 3/8'' hole as shown in (Step 1).
2. Place a bottom beam clamp over the swing hanger as shown in (Step 2).
3. Insert the swing hanger into the beam and thread it into the T-nut until it is flush or near flush with the top of the T-nut.
A screwdriver may be used to twist the hanger, as shown in (Step 3).
4. Orient swing hanger as shown in (Step 4). Use (2) 1-1/4'' screws to secure beam clamp.
5. Make certain the Swing Hanger is seated in the Beam Clamp Slot to prevent spinning.
6. Repeat for all swing hangers.
NOTE: Make certain to alternate Swing Placement on both Swing Beams. DO NOT place all swings on a single beam.
Bottom Beam Clamp
Use Screwdriver to aid in tightening
5-1/4'' Swing Hanger
Swing Hanger
Swing Hanger
(2) 1-1/4'' screws
26
1-1/4'' Wood Screw
Tabla de contenido
