Special Features; Start­up; Switching On / Off / Selecting The Temperature; Temperature Levels - Silvercrest SSHK 100 E5 Instrucciones De Utilización Y De Seguridad

Special features / Start-up

Special features

This heating pad has been provided with an espe-
cially soft and hygienic velour fabric. The textiles used
in this heating pad meet the strict human ecological
requirements of Oeko-Tex Standard 100, as verified
by the German Hohenstein Research Institute.
Start­up
Note: The heating pad may smell of plastic the first
time you use it, but this will disappear after a short
period of time.
To begin, first connect the control
heating pad with the plug-in connector
(see fig. B).
Place the heating pad in position as shown in
fig. C.
Push the two ends of the heating pad together
so the press stud
4
Or use the two press studs
of the heating pad.
To place the heating pad down, undo the press
stud or the press studs
4
Switching on / off / Selecting
the temperature
Switching on:
Set the control unit
switch on the heating pad.
Note: The function display
the heating pad is switched on.
Note: This heating pad features rapid heating,
which allows it to heat up within the first 10 mi-
nutes of operation.
Switching off:
Set the control unit
heating pad.
Note: The operating display
30 GB/MT
to the
1
3
snaps into place.
for a tighter fit
5
.
5
to 1, 2, 3, 4, 5 or 6, to
1
illuminates after
2
to 0 to switch off the
1
will switch off.
2
Selecting the temperature:
Just before using the heating pad, set it to the
highest temperature setting (setting 6). This will
cause the heating pad to warm up quickly.
When using the heating pad for several hours, set
it to the lowest temperature setting (setting 1).
ting the heating pad for several hours,
we commend setting the control unit
to the lowest setting to prevent over-
heating and potential burns to the
part of the body heat is applied to.

Temperature levels

Set the required temperature level on the con-
trol (see fig. A).
1
Level 0: off
Level 1: minimum heat
Level 2–5: customised settings
Level 6: maximum heat
Automatic switch­off
Note: The heating pad switches itself off automati-
cally after about 90 minutes. The function display
then starts to flash.
Then select the setting 0 and after about 5 se-
conds, reset the heating pad to the desired
temperature setting to switch it on again.
If the heating pad is no longer used after
the timer expires:
– switch off the heating pad (Setting 0),
– unplug from the socket,
– disconnect the plug-in connection
control unit , from the heating pad.
1
When opera-
2
, i.e. the
3