Tones (Upper Oven); F Codes (Upper Oven) - Kenmore 911.47722 Guía Para El Usuario

OPERATION
OvenControl, Clockand Timer
(Upper Oven)
Your new control has a series of
tones that will sound at different times.
These tones may sound while you set
the control for an oven function, or at
the end of the oven function It wil_also
a_ertyou that there may be a problem
with the functions. Below are the types
of tones and a brief description of
each
TONES WHILE SETTING THE
CONTROL- When you press a touch
pad you will hear a beep. This beep
will let you know you have placed
enough pressure on the pad to
activate it (The arrow pads do not
beep).
END OF TIMED CYCLE TONE -
At the end of a timed cooking function,
you will hear 3 short beeps followed
by 1 beep every 6 seconds. This
6-second beep will continue to sound
until the CLE/M_OFF pad is pressed
or you may select the special feature
to cancel this 6 second beep from
sounding at the end of future cycles.
TO CANCEL THE 6 SECOND BEEP
1. Press and hold the BAKE and
BROIL pads, at _e same time
for 3 seconds, until the display
shows "SE"
2. Press the KITCHEN TIMER
pad. The display will show
"CON BEEP" (continuous beep).
3. Press the KITCHEN TIMER pad
again. The display will show
"BEEP" (heap canceled).
4. Press the START pad to cancel
the 6-second beep and leave the
special feature mode.
If you would like to return the 6-second
beep, repeat steps above until the
display shows your choice and press
the START pad
A'n'ENTION TONE - This tone wil!
sound if you make an error or an
oversight is made while setting an
oven function
Examples would be:
a. Setting a clean cycle and the oven
door is not properly closed.
b. Setting a function and not pressing
the START pad.
c. Pressing an additional function
pad without first setting a temperature
or time.
d.
ERR will flash if you set an invalid
temperature. Press the CLEAR/OFF
pad to clear the control and the oven
function
Any of these can be quickly identified
by watching the display
PREHEAT TONE- When you
select a cooking mode, set an oven
temperature and press the START
pad, the oven starts to heat. When the
temperature inside the oven reaches
the temperature you have set, a tone
will sound to let you know the oven is
ready for baking
If you set an oven functionand the
control beeps while the display is
flashing "F" and a number or letter
such as "F-.4" or "R," there may be
a problem with the control or oven.
Simply press the CLEAWOFF pad
and wait about an hour Try setting the
function again If the code repeats,
write down the flashing code and call
for service Tell the technician what
code was flashing.
9
20P306-2 ENv'_I 2/14/03, 3:56 PM