Installation; Connection Cable - Electrolux KTI6430E Manual De Instrucciones

12 www.electrolux.com
comes on
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit letter
code for the glass ceramic (it is in the cor-
ner of the glass surface) and an error
message that comes on.

8. INSTALLATION

WARNING!
Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
8.1 Built-in appliances
• Only use the built-in appliances after
you assemble the appliance into correct
Problem Possible cause
There is an error in the
appliance, because a
cookware boils dry. The
protection against be-
come too hot for the
cooking zone operates.
The Automatic Switch Off
operates.
Make sure, you operated the appliance
correctly. If not the servicing by a custom-
er service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the cus-
tomer service and conditions of guarantee
are in the guarantee booklet.
built-in units and work surfaces that
align to the standards.

8.2 Connection cable

• The appliance is supplied with the con-
nection cable.
• Replace the damaged mains cable with
a special cable (type H05BB-F Tmax
90°C; or higher). Speak to your local
Service Centre.
Remedy
Deactivate the appliance.
Remove the hot cook-
ware. After, approximate-
ly 30 seconds activate
the cooking zone again.
should go out of the
display, residual heat indi-
cator can stay. Let the
cookware become suffi-
ciently cool and check it
with the section Cook-
ware for the induction
cooking zone.