Emergency Call Function; Activating / Deactiving The Emergency Feature; Changing The Emergency Channel - Midland G9 Manual De Uso

Emergency Call function

The Midland G9 Plus dedicates a channel to the Emergency Calls: all the
G9 Plus operating within your range, even if tuned on different channels,
can receive/transmit Emergency messages on that channel.
If you keep pressed the EMG button, the communications automatically
switch to the emergency channel ("EC" on the display). An audio signal
will be sent and all the G9 Plus operating within the range will automati-
cally go to the Emergency channel ("EC").
If you have disabled this function, you won't receive/transmit any Emer-
gency Call.
When the radio is operating on the Emergency channel (EC displayed), all
the buttons except PTT and CALL are disabled.
The G9 Plus will return to the channel in use after one minute from the
last transmission.
To return immediately, push EMG. Now you can use all the MENU fun-
ctions.

Activating / Deactiving the Emergency feature

When you switch on the unit, the Emergency function is activated, but
you can disable and enable it again:
1. Press MENU till the display shows EC on.
Select EC of by using ▲▼ .
2.
3. Confirm your selection by pushing PTT or wait for 5 seconds.
When the Emergency function is activated (EMG blinking on the display)
the following functions cannot be used: Scan, Monitor, Dual Watch, Out
of Range.

Changing the emergency channel

The emergency channel originally preset is P8 DCS 50; but you can chan-
ge it according to your needs.
Important: be sure that the Emergency function is active! (EMG blinking).
If you decide to change the channel dedicated to the Emergency function,
do not forget to make the same change to all the radios!
1. Press the MENU button until the display shows EC on.
2. Push MENU again (of displayed) and select the desired channel by
means of ▲▼.
Midland G9/G9E Plus instruction guide | 19