Automatic Operation - kmk R101 Manual Usuario

1. To install the batteries, slide the back cover of the battery compartment and install the batteries according the direction
(+ and -) shown on the Remote Controller.
2. To replace the old batteries, use the same method as mentioned above.

- AUTOMATIC OPERATION

When the Air Conditioner is ready for use, switch on the power and the OPERATION indicator lamp on the display panel
of the indoor unit starts flashing.
1. Use the MODE .select button to select AUTO.
2. Push the TEMP button to set the desired room temperature. The most comfortable temperature setting are between
21°C to 28°C.
3. Push the ON/OFF button to start the air conditioner. The OPERATION lamp on the display panel of the indoor unit
lights. The operating mode is AUTO FAN SPEED is automatically set and there are no indicators shown on the display
panel of the remote controller.
4. Push the ON/OFF button again to stop the unit operation.
NOTE
1. In the AUTO mode, the air conditioner can logically choose the mode of COOL, FAN, HEAT and DRY by sensing the
difference between the actual ambient room temperature and the set temperature on the remote controller.
2. If the AUTO mode is not comfortable for you, the desired mode can be selected manually.
- COOL/ HEAT (Cooling only model without) and FAN ONLY Operation
1. If the AUTO mode is not comfortable, you may manually over ride the settings by using COOL, HEAT or FAN ONLY
modes.
2. Push the TEMP button to set the desired room temperature. When in COOL mode, the most comfortable settings are
21°C or above. When in HEAT mode, the most comfortable settings are 28°C or below.
3. Push the FAN SPEED to select the FAN mode of AUTO, HIGH, MED or LOW.
4. Push the ON/OFF button, the operation lamp lights and the air conditioner start to operate as your setting. Push the
ON/OFF button again to stop this unit operation.
NOTE: The FAN ONLY mode can not be used to control the temperature. While in this mode, only steps 1, 3 and 4 may
be performed.
DRY Operation
1. Push the MODE button to select DRY.
2. Push the TEMP button to set the desired temperature from 21°C to 28°C.
3. Push the ON/OFF button, the operation lamp lights and the air conditioner start to operate in the DRY mode. FAN
SPEED is Low. Push the ON/OFF button again to stop this unit operation.
NOTE: Due to the difference of the set temperature of the unit and the actual indoor temperature, the Air Conditioner
when in DRY mode will automatically operate many times without running the COOL and FAN mode.
TIMER Operation
TIMER ON button can set the auto-on time of the unit. TIMER OFF button can set the auto-off time of the unit.
1. To set the starting time.
1.1 Push the TIMER ON button, then the remote controller shows TIMER ON , the last set time for the starting operation
and the signal "h" will be shown on the DIGITAL DISPLAY area. You are now ready to reset the time to START the
operation.
1.2 Push the TIMER ON button again to set desired unit start time.
1.3 After setting the TIMER ON. there will be a one-half second delay before the remote controller transmits the signal to
the air conditioner. Then, after approximately another 2 seconds, the signal "h" disappears and the set temperature will
reappear on the digital display.
12