Names And Functions Of Indicators On Remote Controller - kmk R101 Manual Usuario

AIR DIRECTION Button: Push this button, the louver can be fixed at a desired angle. The louver swing (upward or
downward) to a certain angle for each press. When the louver swing at an angle which could affect the cooling and
heating efficiency of the air conditioner, it would automatically change the swing direction (upward or downward).
RESET Button: When the RESET button is pushed, all of the current settings are cancelled and the control will return to
the initial settings. (Use a 1mm little round stick to push the button.)
TIMER ON/OFF Button: Push the TIMER button to set the switch on time. Push the TIMER button to set the switch off
time.
CLOCK Button: Push this button to set time.
LOCK Button: Push this button to lock in all the current settings. To release settings, push again. (Use a 1mm little round
stick to push this button.)
LED DISPLAY Button: Led display is to switch on/off the display on indoor unit (if available). For example: in the night,
people need to sleep and do not want too much light, pressing this button will shut down the display and leave the room in
dark (then in the morning, pressing this button will turn on again the display).

3. NAMES AND FUNCTIONS OF INDICATORS ON REMOTE CONTROLLER

DISPLAY R101
1. DIGITAL DISPLAY area: This area will show the temperature and, if in the TIMER mode, will show the ON and OFF
settings of the TIMER. It will automatically revert back to show the temperature after 5 seconds. Under "FAN" operation
mode, nothing is shown in this area.
2. TRANSMISSION Indicator: This indicator flashes once when remote controller transmits signals to the indoor unit.
3. ON/OFF Indicator: This symbol appears when the unit is turned on by the remote controller, and disappears when the.
unit is turned off.
4. OPERATION MODE Indicator: Shows the current operation modes: "AUTO", "COOL", "DRY", "HEAT" and "FAN".
HEAT only available for heat pump model.
5. FAN SPEED Indicator: Press the FAN SPEED button to select the desired fan speed setting (Auto-Low-Med-High).
Your selection will be displayed in the LCD window except the Auto fan speed.
6. LOCK Indicator: This symbol appears when press the LOCK button, and disappears when press it again.
7. TIMER ON/OFF Display: This display area shows the settings of TIMER. That is, if only the starting time of operation is
set, it will display the TIMER ON. If only the turning off time of operation is set, it will display the TIMER OFF. If both
operations are set, it will show TIMER ON/OFF which indicates you have chosen to set both the starting time and off time.
NOTE:
All signs shown in the Fig.2 is for the purpose of clear presentation. But during the actual operation only the relative
functional items are shown on the display panel.
- INSTALL/REPLACE BATTERIES
The Remote Controller uses two alkaline dry batteries (LR03X2).
C
CLO CK
TIM ER ON
TIM ER OF F
1
2
4
6
TIMER O N OFF
7
DISPLAY R51M/E
3
4
5
11