Elecro VULCAN Manual De Instalación Y Funcionamiento página 9

Analogue set-up
Rotate the Temperature 'Set point' dial located on the front of the unit
(see fi g 1) to the required water temperature.
Digital set-up: Thermostat controller / Temperature display
The digital thermostat displays the temperature in ºc
Fig 7.
The digital thermostat fi tted to your pool heater has been pre-
programmed with all the necessary parameters to ensure reliable service
and operation.
All you need to do is set the temperature you would like your water to be
maintained at, this is known as the required set point temperature.
To display / modify the required temperature, press and release the P
button.
The pre-programmed required temperature will be displayed.
Press (3)to increase or
When the correct required temperature is displayed, press and release
the P button. The unit will then revert to displaying the current water
temperature, but will now control the water temperature, to a maximum of
the required temperature.
Item Description
1
2 'Down' button
3 'Up' button
4
5
(2) to decrease the required temperature.
Function
To display / modify
'P' button the required
temperature
To decrease the
value
To increase the
value
'U' button NOT USED
Indicates that the
water temperature
LED –out has fallen below
the required
temperature
7