Use; Commissioning Procedure Or After Boiler Maintenance (T3 Version); (T3 Version); Turning The Machine On - Nuova Simonelli Aurelia II Serie Instrucciones De Manejo

6.

USE

Before starting to use the appliance, the operator
must be sure to have read and understood the
safety prescriptions contained in this booklet.
6.1 COMMISSIONING
PROCEDURE OR
AFTER BOILER
MAINTENANCE

(T3 VERSION)

When commissioning the machine for the first
time or after carrying maintenance switch ON
the machine using the main switch positioned
lower down and on the right and proceed as
follows:
1) If the message "OFF – CLOCK
DISENABLED" appears on the display pro-
ceed as follows in step three.
2) If the message "OFF" appears on the dis-
play press the key until the mes-
sage "OFF – CLOCK DISENABLED"
appears on the display and then proceed
as follows in step three.
3) Switch ON the machine by pressing the
key and automatically water will
exit from the units for 45 seconds to ensure
that the coffee boiler has been correctly
filled.
This cycle cannot and must not be inter-
rupted.
If this cycle is interrupted due to an electric-
ity failure or accidental switching off of the
machine using the main switch, when the
machine is switched on again the cycle will
start again for another 45 seconds.
56
6.2 TURNING THE
MACHINE ON
6.2.1

AURELIA T3 and Digit

SWITCH ON: plug the machine into the
power socket and press the
switch "A" so it is in position "I";
the machine will switch on.
Pressing the switches "B" and "C"
so that they are in position "I" will
switch on the LEDs even when
the machine is switched off.
NOTE: LEDs are installed as standard on the T3
version and Optional on the Digit version.
A B
WARNING
In case the auto diagnosis indicates error or
malfunction, call an assistance centre; the
operator MUST NOT intervene.
The display, which is not illuminated, will
read:
OFF
NOTE: The machine is not operational, since
the main switch only powers the elec-
tronic card.
For electronic card maintenance, turn the
machine off by means of the external main
switch or disconnect the plug.
MANUAL SWITCHING ON/OFF
Automatic On/Off NOT PROGRAMMED
NOTE: make sure that the general switch is
always on the position "I".
The state of the machine will be shown
by the signal:
SWITCH ON: press the
C
Fig. 20
NOTE: on completion of the check up all the
In case the auto diagnosis indicates error or
malfunction, call an assistance centre; the
operator MUST NOT intervene.
WARNING
key for 2
seconds, the buzzer will beep,
the display will light up to indi-
cate the release of the EPROM
for about 1 second. The control
unit will start up an auto diagno-
sis cycle to check the functions,
all the selection keys will light
up.Once the check is completed
the display will read:
HEATING
with the day and time. When
110°C has been reached, the
heating message will disappear
and will be replaced by the
words:
MACHINE READY
WARNING