Setting The Light Intensity - Philips HF3485 Manual Del Usuario

5 Press the SELECT button to confirm (Fig. 10).
setting the alarm
setting the alarm time
When you set the alarm, you set an alarm time and light intensity and you choose the type of sound
you want to wake up to. The alarm is set when the alarm symbol is visible on the display. The light
intensity slowly increases to the selected level during the set sunrise simulation time before the set
alarm time. The default sunrise simulation time is 30 minutes. This is the recommended time, but as
the sensitivity to light differs from person to person, it is possible to adjust the sunrise simulation
time to your own preference (see section 'Setting the sunrise simulation time' in this chapter). At the
set alarm time (after the sunset simulation time), the alarm sound slowly increases in 90 seconds to
the selected level.
Note: You can set two different alarm times, for example if you want to wake up at a different time in the
weekend than on weekdays.
Note: The volume you set for the alarm is also used as the volume for the radio and music on your
USB stick. To set the alarm volume, press the volume increase or decrease button. If you do not want to
wake up to the lamp or to a sound, select a light intensity or volume level of 0. See sections 'Using the
appliance as a bedside lamp' and 'Setting the volume' in this chapter.
1 Push the control lever to the middle position if you want to set alarm 1. Push the control
lever to the top position if you want to set alarm 2 (Fig. 11).
The hour indication of the alarm time starts flashing (Fig. 12).
,
To adjust the time, follow steps 2 to 5.
,
2 Press the menu - or + buttons to set the hour (Fig. 9).
Note: You can only do this when the hour indication flashes. If this is not the case, push the control lever
down and up again to enter the alarm time function. You can also set the alarm time in the menu (see
section 'Menu functions' in this chapter).
3 Press the SELECT button to confirm (Fig. 10).
The minute indication of the alarm time starts flashing (Fig. 13).
,
4 Press the menu - or + buttons to set the minutes. (Fig. 9)
5 Press the SELECT button to confirm or wait for a few seconds (Fig. 10).
The appliance leaves the menu and the display shows the clock time.
,
The alarm time is now set.

setting the light intensity

You can set the light intensity you prefer for the simulated sunrise that takes place before the alarm
goes off.
Note: The light intensity you set is used for the alarm function as well as for the lamp function (see
section 'Using the appliance as a bedside lamp' below).
1 Press the lamp on/off button. (Fig. 14)
Note: It takes approx. 1 second for the lamp to go on. This is normal, the lamp needs to heat up.
Note: You can also set the light intensity when the lamp is out, but switching on the lamp makes it easier
to determine the preferred light intensity.
2 Press the light intensity increase and decrease buttons to select a light intensity (Fig. 15).
You can choose a light intensity between 1 and 20.
If you do not want the lamp to go on gradually as a simulated sunrise before the alarm goes off, set
the light intensity to 0.
EnglisH
9