Precautions For The Remote Control - Alpine NVE-N872A Manual De Hardware

Before Using This System

Precautions for the remote control

a This device is lightweight and compact. Do not drop it or bump it. Do not put it in your
trousers pocket. Doing so could break it, speed up battery wear, or cause malfunction.
a To clean this device, wipe it off with a dry cloth. (If it is extremely dirty, wipe it off with a
Tips
damp cloth that has been carefully wrung out.) Never use benzene, paint thinner or
harsh chemicals. They cause deterioration of the case and paint. Do not leave this
remote control on the dashboard or anywhere else subject to direct sunlight.
Replacing the batteries
Use two AAA-type batteries.
1
Open the cover
Opening the battery cover.
Push on the cover and slide it as
indicated by the arrows then the
cover will be removed.
Remote Control Holder Installation
• If direct sunlight reaches the remote control
mounted on the holder, remove the remote
control from the holder and put it in the
glove compartment.
• If double-sided adhesive tape cannot install
the holder securely, use screws.
Note: Attach the blue protective paper side
of double-sided tape onto the console
box, etc.
12
Replace the
2
batteries
Replacing the battery.
Remove the old batteries. Insert
new ones matching the (+) and (–)
polarities as shown in the diagram
inside the remote control.
Remote Control
Holder
Double-Sided
Adhesive Tape
(Before attaching
the tape, make
sure the mount-
ing locations are
free from dust or
dirt)
Protective Paper
3
Close the cover
Closing the cover.
Push the cover in the arrow
direction until a click is heard.
Remote
Control
Reinforcing Screws
Console Box etc.