Position Of The Emergency Stop Button; Safety Instructions For Transport And Installation; Safety Instructions For Use And Operation - Hupfer SGR Manual Del Usuario

Safety Instructions

Position of the Emergency Stop Button

2.4 Position of the Emergency Stop Button
Figure 1
2.5

Safety Instructions for Transport and Installation

The following aspects are to be taken into account when transporting the conveyor system:
§
When loading, use only hoists and load lifting devices approved for appliances 1,5 times heavier than
the appliance to be lifted.
§
Only use transport vehicles that are approved to carry the weight of the conveyor system.
§
Use transport vehicles that are approved for the weight of the conveyor system.
§
Parts that have possibly been dismantled for transport must be fitted back and fastened before putting
the appliance into operation again.
§
Even in case of a minor relocation switch off the conveyor system at the mains or disconnect it from any
power supply.
§
In accordance with the legal regulations the buyer bears the risk of transportation. Ask the deliverer to
write down visible damages in the waybill.
§
Do not put a defective appliance into operation under any circumstances and inform the supplier
immediately in such a case.
2.6

Safety Instructions for Use and Operation

The following points shall be observed when using and operating the appliance:
§
Staff is to be instructed in the use and operation of the conveyor system before it is started.
§
Loose items of clothing (e.g. scarf or tie) and jewellery are not to be worn when working on the conveyor
system. Otherwise there is the risk of being pulling in by rotating machinery parts.
§
Unimpeded access to the Emergency Stop buttons must be on hand at all times.
§
Make sure that nobody is exposed to a hazard as a result of the activation of the conveyor system
before switching on the appliance.
4330053_A7
Position of the Emergency Stop button (option)
Section 2
Page 11
Belt Conveyor System
SGR | SPV