Lights - GE JVW5301 El Manual Del Propietario

Surfaces
Stoinless Steel Surfoces (on some models)
Do not use a steel wool pad; it will scratch the
surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the brush line. Follow
the cleaner instructions for cleaning the stainless steel
surface. Cleaners with oxalic acid such as Bar Keepers
Friend Soft Cleanser
TM
will remove surface rust,
tarnish, and small blemishes. Use only a liquid cleanser
free of grit and rub in the direction of the brush lines with
a damp soft sponge.
To inquire about purchasing stainless steel appliance
cleaner or polish, or to find the location of a dealer
nearest you, please call our toll-free number:
National Parts Center
800.626.2002
GEApplioncePorts.com
Pointed Surfaces (on some models)
Do not use a steel wool pads or other abrasive
cleaners; they will scratch the surface.
Clean grease-laden surfaces of the hood frequently. To clean
the hood surface, use a hot, damp cloth with a mild detergent
suitable for painted surfaces. About one tablespoon of ammonia
may be added to the water. Use a clean, hot, damp cloth to
remove soap. Dry with a dry, clean cloth.
NOTE: When cleaning, take care not to come in contact with
filters and other non-enameled surfaces.
^,.,CAUTION: When c eaning the hood
surfaces, be certain that you do not touch the light
with moist hands or cloth. A warm or hot light may
break if touched with a moist surface. Always let the
light cool completely before cleaning around it.
Lights {Pyramid Models JVW5301, JVW5361)
^ CAUTION: A,ow
l ights
to cool before
touching,
To change the lights:
1. Before attempting to replace the lights, make sure that
the light switch is turned off.
2. Using a flathead screwdriver, unclip the wire lighting
support and gently pull the support down from the
hood.
3. While holding the socket, twist the light counter-
clockwise to remove. Replace it with a new GU-10
light. Make sure the new light is locked in the socket.
4. Replace the new light and socket into the hood and
engage into the light support.
Y
N
3>
t't3
3>
Z
dl
r"
rn
3>
Z
Z
o •
c-
-..%
Q
C3
CD
Or)
r--
U_
...... _-_ nk:;i;_s-/°