Declaration Of Conformity - Chicago Pneumatic CP86750 Manual Del Usuario

Prensa hidráulica

Ocultar thumbs

Contenido

página de 65

/ 65
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

English

4.2 Operation Instruction for CP86100

4.2.1 Two ways of operation:

• Operate manually: Insert the handle tube (50) into the handle sockets. 2 handle sockets are provided. The upper one(P31) is for high pressure and low

speed; and the lower one(P43) is for low pressure and faster speed. Fig.12.

• Operate by air: Depress the air foot valve(61,Fig.08)

4.2.2 Piston's retraction and Extension

• 3 positions for the handle lever of selector valve: When it is in position 1, the piston rod is retracting;When it is in position 2, the piston rod is stopping

moving;When it is in position 3, the piston rod is extending. Fig.13

4.2.3 Operation

• Turn the handle lever (99) to position 3, then depress the air foot valve (P54), and the piston rod will extend quickly.Warning:NEVER operate manually

(Manual Low Pressure) simultaneously.

• When the serrated saddle gets close to the work piece, change to manual operation.

• Adjust the position of work piece to make sure the work piece and piston rod are aligned properly.

• Start to press the work piece. Insert the handle tube into the high pressure socket (P31) and pump the handle tube, the piston rod extends slowly and

press the work piece. Operator can press by air ,or press by air and manually simultaneously.

• Release the pressure: turn the handle lever (99) to position 2, the pressure on the piston rod will release automatically.

• Retraction of pistion rod:turn the handle lever (99) to position 1, operate by air or manual.NEVER operate manually (Manual Low Pressure) at the same

time.

• When complete, disconnect the air hose from the compressor and clean the machine.

WARNING

Do not exceed the working load limit / rated capacity of the dolly.

WARNING

Make sure that the operator must wear protective cloth, gloves, safety helmet, shoes and ear protector during operating.

WARNING

To avoid accidents, always be aware of any on-going work on the machine. Also, always stay focused on the job to be done.

WARNING

The product and its accessories must not be modified.

5. Maintenance instruction

Do not use damaged/deformed product. If abnormal noise or vibration occurs, stop use immediately, then inspect and ask manufacturer

for help.It is recommended that this inspection be made by a manufacturer's or supplier's authorized repair facility.

The greatest single cause of failure in hydraulic units is dirt.

foreign matter from entering the system. If the jack has been exposed to rain, snow, sand, or grit, it must be cleaned before it is used.

Store the jack, with pistons completely retracted, in a well-protected area where it will not be exposed to corrosive vapors, abrasive dust, or any other

harmful elements.

Periodically check the condition of the product.

Store the product in dry and non-corrosion environment.

Owners and/or operators should be aware that repair of this equipment may require specialized knowledge and facilities. It is recommended that an

annual inspection of the product be made by a manufacturer's or supplier's authorized repair facility and that any defective parts, decals, or safety labels

or signs be replaced with manufacturer's or supplier's specified parts. A list of authorized repair facilities is available from the manufacturer or supplier,

please call them for help.

Any product that appears to be damaged in any way, is found to be worn, or operates abnormally SHALL BE REMOVED FROM SERVICE UNTIL

REPAIRED. It is recommended that necessary repairs be made by a manufacturer's or supplier's authorized repair facility if repairs are permitted by the

manufacturer or supplier.

Only attachments and/or adapters supplied by the manufacturer shall be used.

The design has been validated according to: ASME ASP-2010