BZ-TECH D-6448 Manual De Instrucciones página 293

Programming Guide S-100W - Ver. 1.0
Flush Macro Buffer
This flushes the buffer of all decoded Macro PDF data stored to that point, transmits it to the
host device, and aborts from Macro PDF mode.
Flush Macro PDF Buffer
Abort Macro PDF Entry
This clears all currently-stored Macro PDF data in the buffer without transmission and aborts
from Macro PDF mode.
Abort Macro PDF Entry
Miscellaneous Scanner Options
Introduction
This chapter includes commonly used bar codes to customize how data is transmitted to the
host device.
See Appendix A, Standard Default Parameters for all host device and miscellaneous scanner
defaults. If the default values suit requirements, programming is not necessary.
There are two ways to change a parameter value:
• Scan the appropriate bar codes in this guide. These new values replace the standard default
values in memory.
• For SSI and USB SNAPI hosts, send a "parameter send" command from the host system.
Hexadecimal parameter numbers are shown in this chapter below the parameter title, and
options are shown in parenthesis beneath the accompanying bar codes.
Note: Most computer monitors allow scanning the bar codes directly on the screen. When
scanning from the screen, is sure to set the document magnification to a level where the bar
code can be seen clearly, and bars and/or spaces are not merging.
To return all features to default values, scan the Set Default Parameter bar code. Throughout
the programming bar code menus, default values are framed.
292