BZ-TECH D-6448 Manual De Instrucciones página 178

Programming Guide S-100W - Ver. 1.0
Timeout Between Decodes, Same Symbol
This option is used in presentation mode to prevent multiple reads of a symbol left in the
Device's field of view. The timeout begins when the symbol is removed from the field of view.
It is programmable in 0.1 second increments from 0.0 to 9.9 seconds. The default interval is
0.6 seconds.
To select the timeout between decodes for the same symbol, scan the bar code below, then scan
two numeric bar codes from Appendix D, Numeric Bar Codes that correspond to the desired
interval, in 0.1 second increments.
1 Hour
Beep After Good Decode
Scan a bar code below to select whether or not the decoder issues a beep signal after a
good decode. If selecting Do Not Beep after Good Decode, beeper signals are issued during
parameter menu scanning and to indicate error conditions.
Beep After Good Decode
Do Not Beep After
Good Decode (Disable)
177