Technical Assistance; Pressure Switch Refit Procedure - ELMECO bb Manual De Empleo Y De Mantenimiento

Ecological instructions
All refrigerating machines
must be disposed by the
communal disposal service or
by an equivalent private
authorized company. Take
care not to damage the rigid
tubes of the refrigerator until
they are taken back in order
to be carefully and
ecologically disposed. All
packaging materials used can
be discharged without any
danger.
Old machine discharge
Ecological instruction
(proposed).
The refrigerating machines
manufactured by Elmeco Srl,
like the greatest part of the
refrigerating machinery, like
freezers and air-conditioners,
use freon as refrigerating gas.
Freon, like other refrigerating
liquids, is responsible of the
damages to the ozone layer.
Even though the kind of freon
that Elmeco Srl use for the
production of its machines is
ecological (R404 CE
01.01.2001 rule), the
Company imposes the buyers
to be acquainted with what
follows and to conform to the
following rules.
The slush machines must be
discharged by the communal
discharge service or by an
equivalent private authorized
company.
Remember not to pierce, for
any reason, the refrigerating
circuit containing the gas.

Technical assistance

The repairing of the machine
(example: Replacing power
cord) must be carried out by
an authorized service centre,
using only original spare
parts.
If the supply cord is
damaged, it must be replaced
by the manufacturer, its
service agent or similarly
qualified persons in order to
avoid a hazard.
The out-of-use machines
must be disabled. Disconnect
the plug from the electrical
network and cut the cable.
Pressure switch refit
procedure
When the slush led, cold
drink led and led 1 blink on
the electronic board at the
same time,
This indicates that the
pressure switch intervened to
deactivate the compressor.
In order to refit this device, it
is important to follow the
instructions below:
1st. Remove the drip tray. In
case of 2 tanks slush
machine remove the
left drip tray.
- 17 -
2nd. Push the black button
as shown in the picture.
In order to avoid this
situation to happen again,
verify the correct position
of the machine as in the
pic.5 pag.36 and/or clean
the condenser as described
at pag.14.