Measuring The Opening; Transporting Your Refrigerator - Amana ASB2623HRQ Guía De Uso Y Cuidado

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Do not install refrigerator
near oven, radiator or other
heat source. Wf n ot possible, shield refrigerator
with
cabinet material.
Do not install where temperature
falls below 55 ° F
(13° C} or rises above 110° F (43 ° C}. Malfunction
may occur at this temperature.
Refrigerator
is designed
for indoor househomd
appmication
onmy.
Measuring
the Opening
When installing your refrigerator,
allow '/_"space at top
and '%' space behind machine compartment
cover
(located in the tea0 for proper air circuhtion.
If the
refrigerator
is placed with the door hinge side against
a wall, you may want to allow additional
space so the
door can be opened wider.
Subfiooring
or floor coverings
(i.e. carpet, tile, wood
floors, rugs} may make your opening smaller than
anticipated.
Some clearance
may be gained by using the leveling
procedure
under Leveling.
UMPORTANT:
If refrigerator
is to be installed into a
recess where the top of the refrigerator
is completely
covered, use dimensions
from floor to top of hinge cap
to verify proper clearance.
Transporting
Your Refrigerator
NEVER transport
refrigerator
on its side. If an
upright
position is not possible, lay refrigerator
on its
back. Allow refrigerator
to sit upright for
approximately
30 minutes before plugging
it in to
assure oil returns to the compressor.
Phgging
refrigerator
in immediately
may cause damage to
internal
parts.
Use an appliance
doily when moving refrigerator.
ALWAYS truck refrigerator
from its side or
back-NEVER
from its fronL
Protect outside finish of refrigerator
during transport
by wrapping
cabinet in blankets or inserting
padding
between the refrigerator
and dolly.
Secure refrigerator
to dolly firmly with straps or
bungee cords. Thread straps through
handles when
possible. Do not overtighten.
Overtightening
restraints
may dent or damage outside finish.
Door and Hinge
Removam
Some installations
require door removal to get
refrigerator
to final location.
1. Unplug
power cord from power source°
2. Remove toe grille and bottom bracket covers (see
page 7}.
Open both doors 180 °, or as wide as possible.
it:or ice and water
dispensing
models
only:
Remove the left side bracket cover by carefully
pulling the water line to pry the cover loose. Then
continue to maintain downward
pressure to the
notched side of the cover while swinging
it off
(see page 7}.
. For refrigerators
in operation,
shut off water before
removing water line from the door.
To Disconnect
the Water Line:
Push in white collar (A} and hold.
Pull the door-side
tube (B} from the connector.
To Reconnect
the Water Line:
, Firmly push tube %" into the connector.
Use
lines on the tube as a guide for full insertion.
Tabla de contenido
loading

Tabla de contenido