Joeforms
in inlet
Water pressure is How.
Water pressure must be between 35 to 1O0 pounds per
tube to ice maker
square inch to function properly.
A minimum pressure of 35 pounds per square inch is
recommended for refrigerators with water fiHters.
SaddHevaHvenot open compHetdy.
Open saddHevaHvecompHetdy.
Freezer temperature is too high.
See 7_emperature Controls pages 8 and 9. Freezer
temperature shouM be between 0° to 2° F (-18° to -17° C).
Refrigerator
is
PHastictubing was used to compHete
The manufacturer recommends using copper tubing for
leaking water
water connection,
installation. PHasticis HessduraMe and can cause
Heakage.The manufacturer
is not responsibme for
property damage dae to improper
installation
or
water connection.
Improper water valve was installed.
See Connecting the Water Supply pages 4 and 5. Self-
piercing and _;" saddle valves cause low water pressure
and may clog the line over time. The manafactarer
is
not responsible
for property damage dae to
improper installation or water connection.
Water flow is
Water pressure is low=
Water pressure must be between 35 to 1O0 pounds per
slower than normal
square inch to function properly. A minimum pressure
of 35 pounds per square inch is recommended for
refrigerators with water filters.
Saddle valve not open completely.
Open saddle valve completely.
Improper water valve was installed.
See Connecting the Water Supp/y pages 4 and 5. Self-
piercing and S_"saddle valves cause low water pressure
and may clog the line over time. The manafactarer
is
not responsible
for property damage due to
improper
installation
or water connection.
Copper tubing has kinks.
Turn off water supply and remove kinks.
If kinks cannot be removed, replace tubing.
Water filter is clogged or needs to be
Change water filter (see page 18).
changed.
Water valve not opened completely.
Open water valve completely and check for leaks.
The minimum flow at dispenser is approximately
10 fluid ounces in nine seconds with a new filter in
place or approximately 10 fluid ounces in five seconds
without a filter.
Dispenser water
Allow approximately 12 hours for water in holding tank
is not cold
to chill.
Refrigerator has been recently installed.
Water supply in holding tank has been
depleted.
Water has settled into water lines
outside holding tank and has warmed to
room temperature.
Air or air bubbles in water.
Discard first glass of water and refill.
This is normal when first using the dispenser and will
cioady
disappear with use.
Particles in water
Carbon dust from water filter cartridge.
Initial water ejected through cartridge may contain
and/or ice cabes
harmless carbon dust flushed from cartridge.
Particles are safe for consumption.
Will disappear after the first few uses.
Concentrations of minerals in water will
Particles are not harmful and naturally occur in water
form particles when water becomes
supplies.
frozen and melts.
32