DM 2610919778 8-03
8/4/03
Operating Speeds for Accessories - (cont.)
The speed of Model 800 is controlled by rotating this
dial to desired setting on dial
Switch Setting
0
* 2
5,000 – 11,000 RPM
4
12,000 – 20,000 RPM
6
21,000 – 25,000 RPM
8
26,000 – 30,000 RPM
10
31,000 – 35,000 RPM
*2 is the maximum speed setting for wire brushes.
To aid you in determining the optimum operational
speed for different materials and different accessories,
we have constructed a series of tables that appear on
page 13, 14 and 15. By referring to these tables, you
can discover the recommended speeds for each type of
accessory. Look these tables over and become familiar
with them.
Your 10.8v Cordless Rotary Tool can be used with all
screw-on attachments for added versatility. A few
older attachments, such as 2217 Tool Holder, 330
Router, and 231 Shaper / Router Table are not com-
patible with the 10.8v Cordless Rotary Tool.
4:06 PM
Page 11
Ultimately, the best way to determine the correct speed
for work on any material is to practice for a few min-
utes on a piece of scrap, even after referring to the
chart. You can quickly learn that a slower or faster
speed is more effective just by observing what happens
as you make a pass or two at different speeds. When
working with plastic, for example, start at a slow rate of
speed and increase the speed until you observe that the
plastic is melting at the point of contact. Then reduce
the speed slightly to get the optimum working speed.
Some rules of thumb in regard to speed:
1. Plastic and materials that melt at low temperatures
should be cut at low speeds.
2. Polishing, buffing and cleaning with a wire brush
must be done at speeds below 15,000 RPM to
prevent damage to the brush.
Speed Range
3. Wood should be cut at high speed.
OFF Position
4. Iron or steel should be cut at top speed if using
tungsten carbide accessory, but at slower speeds
if using high speed steel cutters. If a high speed
steel cutter starts to chatter — this normally
means it is running too slow.
5. Aluminum, copper alloys, lead alloys, zinc alloys
and tin may be cut at various speeds, depending
on the type of cutting being done. Use paraffin or
other suitable lubricant on the cutter to prevent
the cut material from adhering to the cutter teeth.
Increasing the pressure on the tool is not the answer
when it is not cutting as you think it should. Perhaps
you should be using a different cutter, and perhaps an
adjustment in speed would solve the problem. But
leaning on the tool seldom helps.
The 212 Drill Press requires a free adapter kit
(available April 2004) which you can get by calling
Dremel at 1-800-4-DREMEL.
The 225 Flex Shaft is compatable with your tool, but
you may experience reduced run times when using it.
Página 11